Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi all, I'm now to the FMC API, and FTD in general. I have been tasked with creating an automated process to disable a subinterface on an FTD.  I am able to pull the subinterfaces, but do not appear to be able to change the state via the API.  I hav...

tmagill_sig by Frequent Visitor
  • 4512 Views
  • 7 replies
  • 0 Helpful votes

Our company has two IPS planning an IPS to USER using the Internet access, and the other would like to establish a branch to the branch office for the use of the company's internal services, whether both site are Cisco ASA equipment can achieve this ...

I have a FW (2) that have to segments one for data and one for voice (see attched image) and I want that those segments reach the servers segment behind another FW (1) also between the two Firewalls there is L3 switch.(image attached) Could you pleas...

Hi This maybe a quick answer for you out there.I am not a Cisco tech but have enough to understand basic networking.I need to install new ASA firewall and Router, and I am not sure which one to go - Cisco ASA 5506-X or Cisco ASA 5516?I have 75 users,...

aaleonardo by Community Member
  • 615 Views
  • 2 replies
  • 0 Helpful votes

Hi, If i wanted to install on ASA Software on 41xx Chassis, what license we require? as far as i know, we can't Install FTD if we install ASA SW, so we don't need FMC to manage the Firewall? will also the old ASA CLI be available or do we need to In...

1.       Can share if SourceFire have support coverage in these countries?2.       What SLA are available?3.       Can we engage the remote service to help reconfigure back to last config and so as that we can remote via internet for any further setu...

leongsk by Cisco Employee
  • 1570 Views
  • 2 replies
  • 0 Helpful votes

Hello everyone,  I am in the process of upgrading the flash via EUSB on one of ISR 4331 routers.  Does anyone have any experience performing this upgrade and can provide detailed instructions for upgrading the EUSB.   I have researched Cisco's site...

hi all, I have pair of 4110 in another site accessed via VPN.is there any port or specific protocol that should be allowed on VPN so FMC can communicate with the FW?  the FW registers, it goes through discovery and de registers on FMC due to communic...

cisco8887 by Level 5
  • 630 Views
  • 1 replies
  • 0 Helpful votes

If someone could please help, I would appreciate it.  This tunnel reports up (via show vpn-sessiondb l2l).  But no traffic will pass.  Seems to get denied at Phase 2.  Something wrong with ACL it says.  I'm not seeing.  Wizard wrote the config includ...

gregb71298 by Frequent Visitor
  • 2035 Views
  • 10 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card