Network Security

Hi, hope someone can help as i have an ASA 5505 series firewall and have it configured as below but i get'unable to open webpage' when trying to access ASDM via https://192.168.10.1--------------------------------------------------------------ciscoas...

Hi, we have 2x 5510 in standby/failover mode going to 2x 2960s switches The following are the interfaces: E0 = OUTSIDE (block of 8 public ip's)E1 = INSIDE E2 = Standby (state failover)E3 = vlan 299 going to another ASAM0 = Standby (Lan failover) We ...

1. do "hw-module 1 reload" to reload IPS cause failover that make ASA02 become active if ASA01 originally is active? 2. is this command "hw-module 1 reload" only can apply to active unit ?   in another words, if i type this command in secondary unit ...

Hi All, I have a branch ASA 5505 with a VPN tunnel over a T-1 WAN to the data center, which has a centralized internet pipe. Branch ASA 5505=========VPN TUNNEL===========Data Center ASA 5520=====Internet Pipe I am trying to roll out hierarchical prio...

Hi guys I have a situation when used ASDM to configure the firepower module on the ASA 5506-X.I create a object to filter a URL for example, cisco.com, but when I put that on my policy, the firepower doesn't do anything and the traffic flow is normal...

Hey Im migrating a large 8.2 configuration and there is a lot of cleanup and manual labor since the converted configuration is a mess. I somewhat think I understand "proxy arp", but when testing for example a web server nat'ed from a dmz or somewhere...

Hi, i'm trying to establish a HTTPS connection to my ASA from another "site" in packet tracer. I can ping across the sites and into the "inside" network of the other site but cannot HTTPS into the ASA or the web server itself also. Here is the config...