Network Security

Hi All,I have a pair of 6506's with FWSM modules within (at version: FWSM Firewall Version 4.0(6) ; Device Manager Version 6.1(3)F ) .Recently, the ability to write running-config to start-config has failed. After 2 sessions with Cisco TEC which invo...

I thought I had done my last PIX to ASA conversion, but I was sadly mistaken.  Here's the problem I'm having.  I currently have an install with a pix515 we are trying to replace with an ASA5525x.  I tried replacing it after going through and updating...

Got an ASA5506 with FirePower module.  I can only access this via ASDM on the management interface.  I changed the IP so it ran on my "inside" but it can't contact the module on that IP and it takes an age to loads the ADSM without it.  Is this possi...

Hi guys I have configured a asa 5505 for webvpn and anyconnect client .Webvpm work properly as I expect grant acces to server and so onAnyconnect estabilish connection and try to acces at server on inside network without success, I attach config and ...

HiI've just unboxed my 5525-x and connected the management interface to the network. Gave it an ip address in the correct subnet but the interface does not come up.logs show:IKE port 10000 for IPSec UDP already reserved on interface managementHow is ...

Hi All I have configured 3 zones on my router using the zone based firewall. Everything was working fine for a few hours but then traffic suddenly all Internet traffic was blocked on the Outside interface. I could access the router from the inside an...

Dear Experts I have a big problem , i have one proxy with static nat to public IP. This proxy allow users to get internet access after 30 mins become down , i checked with my ISP and proxy vendor and both confirmed that there is no issues from their ...

Hi Guys, As i can see, Cisco is recommending for the ASAs to be in transparent mode in data centers, my question, why not routed mode?How to decide? what is the problem in having the routing on ASA?I know that transparent mode is easier to place, but...

We are setting up a new network using a Cisco 2960-X switch through a Cisco ASA 5525 to get to the Internet.  The Cisco 2960-X is set up with  VLANS and the interface with subinterfaces have been created on the Cisco ASA.  As far as we can tell we ar...

All, I've recently started to configure a NAT'ing policy for a cisco ASA 5515 (using FirePower) and I have run into some seriously odd issues.  Here's the basic scope.Physical Config:single upstream (1 Public in a /26) link on ASA rest are downstream...

we need to sanitize several SG300-10 managed switches.Is there a sanitization document for this? thanksmike

I have the threat-detection setup like the following:threat-detection rate scanning-threat rate-interval 600 average-rate 6 burst-rate 20threat-detection rate scanning-threat rate-interval 1200 average-rate 5 burst-rate 15threat-detection rate scanni...

Hi, I've three question please. 1- I have one public ip only, any  on the outside need to access a server on the inside on port Ex: 5000i think the command should start :   nat ( outside, inside) ....  2- some users online they implemented a similar ...