Network Security

Hello all,I´m setting up a pretty basic lab on GNS3 and I´m getting a weird issue on my DMZ. I have a LAN interface and a DMZ interface, currently both with security-level 50 (lab purposes only), I think I have everything setup but host on both ends ...

I've read through dozens of posts and so far have had no luck getting any of the suggestions to work - combined with many of these posts being multiple years old...so I'm going to try posting something current and see if I get anywhere. Scenario:Site...

Hello All I'm new to the ASA (or firewalls in general) and I'm getting a little stuck with allowing traffic between interfaces.  I have two interfaces currently setup and they are used for my inside traffic (connects to a cisco 2611 router) and my wi...

Dear Support, I am having the ASA 5515 and in this ASA CX module install for contain filtering.I have configure the some policy in CX module through PRSM GUI.I also enable ssh for CX module. My CX module is not have any problem all my policies are wo...

version 8.2(5) is presently installed and running fairly well, however, we need to upgrade the code on the firewall to bring it up to spec. when trying to following the upgrade path to 8.4(6) the following errors occur after the reload. Please advise...

Recieved an RMA FWSM and cant console to it. Cisco shipped with OS version 2.3 so cant session into it. Console hangs during bootup.  The old FWSM being replaced is hardware verison 3.0 and the new is 4.5.Is there a a requirement for hardware version...

I have having serious issues with performance on my ASA 5505s that I am testing with 9.2.3 code.I stripped the config and removed as much stuff as I could - no VPN etc. and I am ONLY getting about 30-40Mbps downloads from sites but 95Mbps uploads????...

Hi All,Today I completed an upgrade of an Active/ Active ASA set-up based on 5585-X hardware. The original software version was 9.1(4), the newly installed version is 9.2(3).Since reloading with the new version alerts (severity 1) related to SCPS are...

Hello friendsI am getting a strange behavior in CSM version 4.4. I have successfully added a Router to the Device Inventory, and then when I try to add it to a Policy Bundle that I had already created, I am getting an error message at the time I try ...

Hi all, I have a Pix 515e version 6.1(5) I need to let PPTP pass through, is there any special configuration I have to do? I have already enabled the pptp on the ACLs. Thanks.

Hello, I have a network object group that contains individual objects and additional object groups. Is there a way to export this showing the IP address, netmask and description? I don't really mind having to export more than what I'm specifically lo...