Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I'm trying to install ACS onto a VM following the Cisco VM install documentation but the install fails when its trying to install ACS after the OS has been installed successfully.See screenshot for errors.Has anyone come across this error previously ...

jonhill by Level 3
  • 657 Views
  • 1 replies
  • 0 Helpful votes

Hi All,New to the world of IPS and Firepower. Wondering if these devices must sit inline or just on the network somewhere? Currently have a 2951 as edge facing device and the plan would be to put a 5515-X with FirePower "behind" that device. Just won...

Hello,i need to manage an active/standby ASA CX configuration with PRSM Multidevice mode. Is it possible?I read on documentation:If the ASA is in multiple-context mode, you can still manage a CX moduleBut it seam to be possible only with single mode ...

Firewall:  ASA 5550 VPN Premium license Version 9.1(5)16Incident as below:  Nat statement as below===================name 9.x.x.x NAT-E23ESMTP01  nat (SMTP-YELLOW,inside) static 9.x.x.xobject network obj-202.x.x.xobject network NAT-E23ESMTP01 host 9....

mm6646 by Community Member
  • 757 Views
  • 2 replies
  • 0 Helpful votes

I have an ASA 5515X firewall running on software version 9.1(1). Does anyone know how to properly disable SSLv3 on this device? This is in regards to addressing the POODLE vulnerability. Thank you.

vdang0001 by Community Member
  • 2010 Views
  • 1 replies
  • 0 Helpful votes

I recently attended a Cisco webcast and was told it is possible to get a free migration from the legacy IPS license to the firepower license if you have a 5500x series ASA.  Did anybody able to successfully getting the free conversion?

pmlam3274 by Level 2
  • 1186 Views
  • 4 replies
  • 0 Helpful votes

Good morning everyone,I'm going to be upgrading a pair of 5510's to 5525x's and with the exception of adding a new interface for failover on the 5525x's, since the 5510's  are using the MGMT interface for failover, and yes I know that this isn't best...

Review Cisco Networking for a $25 gift card