I am going to install ASA5525-X Firewall in HA mode and both have Software IPS modules and I was wondering how the management IP address will be configured in HA mode. Is both IPS will have same management IP address?I looking for some sample config ...
I was able to access the ASDM launcher in the browser yesterday via https://192.168.111.1/admin and I was stuck there as the browser version says that my ASA image does not work with my ASDM version... So i tried some trouble shooting and t...
Hi everyone,I am very new to configuring the ASA particulary after the change to how NAT is implemented. What I am trying to accomplish logically seems fairly simple, yet I cannot get it to work. I have a Synology NAS at home that I am trying to re...
Tengo un ap 3500 con acceso por controladora y lo necesito configurar autonomo, me han dicho que se puede hacer cambiando la version del firewall, si es asi por favor me pueden informar ¿donde lo puedo descargar? o si me pueden dar otra solución.
Hi I have an Cisco Asa 5520 and i want to make vpn site to site using another interface with a lan to lan carrier, the problem is when i try to pass traffic have the follow syslog error:No translation group found for udp src lan2lan:10.5.50.63/44437...
Hi Community, all helpful responses rated! We have some Cisco ASA5550's running code release 7.2.4. We are planning on upgrading these to 8.0 -> 8.2 -> 8.4 -> 9.0.3, step upgrade as proscribed by Cisco. Now due to the nat-control and NAT syntax chang...
Hi I have on firewall in a different LAN segment and I want to access that firewall through asdm however I am sitting in outside zone for that particular firewall.
Hi Everyone,When ASA is in Active/standby failover i can ssh to standby ASA using Radius.But when ASA is in multi context mode Active/Active failover i can not do Radius Auth to standby ASA?Is this default behaviour?RegardsMAhesh
Hi,We intend to replace our existing ASA5520 firewalls (including IPS modules) with new ASA5545x firewalls including IPS licenses. As these are production firewalls, I was wondering on the best strategy to replace the firewalls while minimising down...
Hello all, I am trying to figure out what I am missing in regards to getting ASDM to run without the attached warning. If I update my Java ASDM will no linger work. I can uninstall Java, re-install my lower version and ASDN starts working again just ...
I noticed that the CPU on our ASA had jumped from around %4 to 30% consistently a few weeks back. The process below seems to be causing the load, but I can't find any information on what it does and how to resolve the issue.ASA# sh proc cpu-usage so...
We are trying to set up email continuity through Mimecast. Part of the set up is active directory synchronization. In order for that to happen, the DC will need to communicate with Mimecast. Currently the DC does not have a public IP. We were tol...
Hi all: I just got my new ASA 5515 X firewall and I got stuck in the first steps. I can ping a public IP (8.8.8.8) from the device but I cannot ping it from my LAN. I know I am missing either NAT rules or Access rules or maybe both, but I need some h...
