Anybody experience this issue before?
Switch model: WS-C2960S-48FPD-L
Mix stack with 2960-X
We upgrade the IOS software from C2960S-UNIVERSALK9-M), Version 15.2(2)E6 to version C2960S-UNIVERSALK9-M), Version 15.2(2)E7
After reboot, the...
I have a question regarding LACP between ASR9K to Cat 4500 (IOS).
I never tested the setup before and not sure if it will work.
is the configuration below is sufficient to bring up the LACP between the router?
Cisco ASR9K bundle-interface c...
I need an advice here on a setup for Cisco ASA.
Is there any possibility to perform a PAT from Public IP to an IP that is located in the firewall in remote site which connected to HQ ASA via IPSEC?
Attached is the diagram of the setup.
Im currently facing an issue with l2l ipsec between Cisco ASA (9.X) to Cyberoam Firewall.
We have Phase 1 and Phase 2 with PSK matched, but seems like the ASA stuck in MM_WAIT_MSG6
The Cyberoam Firewall is not behind any NAT device while t...
I know this thread has been a year, but just to update. The link provided no longer showing the full back site of the FMC interface anymore.And the guide did not show on how to use the 10G interface in the FMC (which is eth2 in FMC).
Seems like it hits the version as well. It hits 1 of our switch.
ROM: IOS-XE ROMMON
BOOTLDR: CAT3K_CAA Boot Loader (CAT3K_CAA-HBOOT-M) Version 3.56, RELEASE SOFTWARE (P)
SW01 uptime is 23 weeks, 5 days, 18 hours, 57 minutes
Uptime for this control ...