Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I have a Cisco 5520 with the ASA-SSM-10 IPS Module. I am running version 6.1(2)E3. I need a way to whitelist an IP Address from a Security Scanning vendor. The vendor is Control Scan and everytime they try to certify our site it fails because the IPS...

dblount by Community Member
  • 6369 Views
  • 3 replies
  • 0 Helpful votes

Hi All,I am in quite the predicament, my company offers a cloud based infrastructure for customers who buy our software from us. We have a pair of ASA 5525-X w/ IPS with multiple vLAN's for each customers (inside) and one vLAN for our outside interfa...

Jazz80813 by Community Member
  • 2930 Views
  • 8 replies
  • 0 Helpful votes

Hi, We're using port based ACL in our ASA firewalls for site to site VPNs, it was working fine. However, after upgrading one of the firewalls to 8.4, we started to have issues. We then changed it to IP based and it fixed the problem. Are port based c...

punchhab by Community Member
  • 1062 Views
  • 1 replies
  • 0 Helpful votes

I know I have to purchase a security plus license to get gigabit speed on the asa-5510. The problem is the system is fully configured and online and the ports I want to upgrade are not e0/0 & e0/1. Is there any reason to limit which ports can be upgr...

Please help and suggestion on below point.I'm configuring vlan 3 on port 3 on firewall but is not pingable although I connect directly to the port.My goal is from my PC 10.10.10.X can access internet through vlan3 10.10.10.250. Here is my Firewall co...

baryanto1978 by Community Member
  • 1051 Views
  • 5 replies
  • 0 Helpful votes

Hi guys, I just have a doubt that, if I configure the active and standby mac address in failover, does it will cause any downtime? As I planning to configure the active and standby mac addresses in failover during production time and not wish that it...

Chin by Level 2
  • 5632 Views
  • 8 replies
  • 0 Helpful votes

 Hi all ,  I have ASA 5515-X with SW, 6 GE Data, 1 GE Mgmt, AC"PID: ASA5515  Licensed features for this platform:Maximum Physical Interfaces       : Unlimited      perpetualMaximum VLANs                     : 100            perpetualInside Hosts     ...

startx001 by Level 4
  • 1683 Views
  • 5 replies
  • 0 Helpful votes

Hello, I have a webserver on the DMZ and I want to capture all source traffic going to it's public IP.  I have used the ASDM packet capture before, but can't seem to get this traffic to show up. My webserver is on (example) 80.170.156.86 (Outside) an...