Network Security

Good day,I am curious where a startup-config is being stored.I try securely download startup-config to windows C:\Temp file, but FW is disconnecting pscp request.Our Cisco ASA has single mode context.When I try to download any file located in disk0:/...

Hello. I would like to configure redundant interfaces on my ASA 5510 and have a few questions on how this works. I have a Untangle internet filter between my ASA and clients currently in a Vmware environment. If I vmotion the Untangle filter to anoth...

I have a customer that is using FWSMs.  There are 4 interfaces  (inside 100 , outside 0 , dmz 50 , wireless 4 ). So to give an example: 1) I connect to the wireless and get an address of 192.168.1.x.  My DNS server is on the dmz and I can resolve add...

I need to create pat for all inside address ranges to the outside interface ip on Cisco ASA 9.1- Help!The inside address ranges are:192.168.1.0  255.255.255.0192.168.2.0  255.255.254.0172.17.1.0  255.255.255.0172.30.1.0  255.255.255.0172.30.2.0  255....

I checked under our service policy in March and the icmp packets were at 13,743Inspect: icmp, packet 13743, drop 0, reset-drop 0I checked it again today and its now at 1,608,004Inspect: icmp, packet 1608004, drop 24, reset-drop 0 Anybody know what co...

I'm trying to configure an ASA to replace my last PIX.  Since the last ASA I did the language has changed.  What we have are about two hundred normal users that need to surf and share one public IP from the ISP to get it done.  I have about a few box...

HiI have a suspected DDOS attack goin on. Ive got a 5550 with software ver 8.0Im looking for tcp sessions whitch dont complete the setup.Im using the show local-host command but theres a lot of output to read through. Is this the best way to try and ...

Hi, i have a weirs issue where i can access the ASA with ASDM and save the config ok but i can't apply any changes, we are using ASA 9.1(2) and ASDM 7.1(3)

Hi, I'm trying to configure PAT on a new ASA-5510 running 9.0(3) and I'm having some issues. In our setup we have a single public IP address(lets say 127.1.1.1) which is assigned to the outside interface, and we need to use that for both dynamic PAT ...

OK, I have this issue where we have a need for some Bandwidth combining and failover, etc, so the client has a TP-Link installed.  From there it goes to the ASA, and from the ASA to the local LAN.Customer has a camera system he wants to be able to se...

Dear Sir,In my ASA i am getting the message is like thisDeny IP spoof from (127.0.0.119) to 108.122.0.0 on interface MZ-ACCOfter that i enable IP VERIFY REVERSE-PATH command on the MZ-ACC interface ofter enabling i showing the below msg106021    127....

Hi Cisco Support teamPlease can you advise the trigger conditions of for VxWorks Remote Debug Interface signature 28779/0 which occurs on destination port 17185 . We have noticed that this signatures fires usually during a penetration test.