Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I have an old 5505 that I want to configure at home. I plug it in and it powers on. I connect my management cable to it and use a USB to serial to my pc and its on COM4. I go to my secureCRT and connect to com4 and get the green check mark...
This is the scenario. I have multiple routers running in pim spare-dense mode. When the RP goes down they will retry to find the RP for 30 seconds and then 2 more times until it finally times out after a minute and a half then rolls over to dense mod...
I am trying to calculate how many bytes are added to a packet as it traverses through the network. For example I send a 100 byte ping to my desktop and in wireshark it shows the length as 114. So tells me icmp adds 14 bytes. And then is there a way t...
I have a 2911 router that is running 15.4. I have CME 11 but I know the CME needed with this iOS is 10.5. If I install CME 11 on this router will it convert to 10.5?
