Network Security

Hello,I'm setting up a CSC card and seem to have every thing in place.  The card has a good connection to both the Domian control agent and Domain control server.    However when I attempt to create a policy I get no LDAP users/groups listed.I've bee...

Hi All,Faced some kind of strange problem when setting up VPN tunnle between cisco routers & Juniper ISG firewall.Problem what we faced is , VPN tunnel came up in phase-1 & phase-2 also and we were able to to icmp & telnet test as well.however when u...

HiCan we run IPS and web security on the same platform. Any product in cisco which supports above requirement .Thanks & Regards Lakshman Kumar S

Setting  up asa5510 - i have six interfaces.  Had planned on putting them all at the same secuirty level and then using ACL;s to allow specific traffic.  However I haven;t been able to get any traffic through any ports even with permit ip any to any ...

Hi everybody,thanks for an excellent forum!I have a wierd problem with 3 ASA 5505s... They are set up on a small lan to serve as dhcp server, very flat straight forward setup - single vlan with a couple of phones printers pcs and such.Now. When the l...

We are getting below trace, 1st hope is a ASA 5510 and source subnet is patted on another ipHow can we stop thisTracing route to 146.89.103.9 over a maximum of 30 hops  1     9 ms     1 ms     1 ms  146.89.103.9  2     2 ms     1 ms     1 ms  146.89....

                  Hello,I hav ASA 5550 with 9.1(2) IOS and ASDM 7.1The problem is connecting to this asa with asdm and connecting to https. I tried every thing I know.I downgreadet java and tripple checked my configuration and even erased the whole c...

Hello Guys,One month ago i installed a FW ASA 5515 in my network, this Firewall came with an internal module CXSC but in this moment i have that module in shutdown state.Since i installed the FW ASA 5515X in my network i am facing a issue with the Go...

Hi ,One of our customers complained that the inspection load (3-5%) he is seeing under ASDM is not what he usually see. He thinks it is too low and he expects it to be atleast 30% as it was before.We want to check if IPS is performing its duty, as in...

I have an ASA5510 with an CSC module and It all worked fine till yesterday when I tryed to log into the module but I get this error: Opening command session with slot 1.Connected to slot 1. Escape character sequence is 'CTRL-^X'.Login incorrectRemote...