Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

HiI'm new to firewalls, so apologies if i'm wrong anhywhere.Here is my setup.I have a cisco C3560 switch with multiple VLansIt is connected to ASA 5505 which is further connected to Internet. C3560 <--> G0/46 <--> 10.40.250.2 <--> 10.40.250.1 <--> E0...

sysadmin by Community Member
  • 1166 Views
  • 1 replies
  • 0 Helpful votes

HiI'm new to firewalls, so apologies if i'm wrong anhywhere.Here is my setup.I have a cisco C3560 switch with multiple VLansIt is connected to ASA 5505 which is further connected to Internet. C3560 <--> G0/46 <--> 10.40.250.2 <--> 10.40.250.1 <--> E0...

sysadmin by Community Member
  • 1277 Views
  • 1 replies
  • 0 Helpful votes

im trying to creat a port for a app on a desktop computer. the computer is the only computer pluged in to vlan1 ip address 192.168.5.2.ip trying to open port 32669. i thought the nat to the inside would do it but when i try and open the app it still ...

After releasing signature update S749, we discovered a defect that significantly impacted the performance of the AnalysisEngine application running on the sensor. This defect is documented in CSCul00198. Having identified the root cause of the proble...

wsulym by Cisco Employee
  • 4380 Views
  • 4 replies
  • 0 Helpful votes

Hello Cisco Support Forums!I have a "simple" question regarding static routing on an ASA 5510 and metrics. I just want to confirm that if I add the following configuration that the Route 1 will take precedence over Route 2 due to the metric value bei...

TomServo6 by Frequent Visitor
  • 3924 Views
  • 3 replies
  • 5 Helpful votes

Here goes:I have VPN Licenses and would like to start using them, unfortunately ASA is not as straight forward to set up I tried the wizard with no success. an guide on how I can setup remote access so the users can jump on RDP sessions? attached is ...

wperez001 by Community Member
  • 1620 Views
  • 4 replies
  • 0 Helpful votes

Hi all,   I'm new to ASA's and also since it's been a while since I configured any Cisco device, I'm re-learning most of this stuff, we got a new asa 5510 (actually a refurb) and need to get it setup into our existing network, I read it would be easi...

Carlomd by Level 4
  • 8217 Views
  • 14 replies
  • 0 Helpful votes

I am wondering if someone can shed some light on this for me. I have a new ASA 5505 with a somewhat simple config. I want to set up a guest VLAN on it for a guest wireless connection. I set up the ASA with the VLAN, made a trunk port, set up DHCP (on...

J W by Level 2
  • 1274 Views
  • 5 replies
  • 0 Helpful votes

Hello,I´m trying to remake this BSD:map ep0 172.16.0.0/16 -> 216.68.250.60/32 portmap tcp/udp 10000:20000line says go ahead and map all tcp/udp traffic right on through the interface and assign each out bound "connection" a port from 10000 to 20000in...

mareks-vader by Community Member
  • 2228 Views
  • 8 replies
  • 0 Helpful votes

Hi, This is my setup:Comcast 100/10ASA 5505190 Wirelss Devices40 Wire computersI am expiriencing websites timeouts and very slow to browse the internet. I notice it always gets slow when the number of xlates and connection goes above 1100.What i have...

JaydGonz480 by Frequent Visitor
  • 9849 Views
  • 10 replies
  • 0 Helpful votes

I have a situation.I have a web server on the outside with an ip of 62.61.107.68 , my asa is 62.61.107.78 , my inside is 10.1.15.1-254I put a DMZ Switch where the server connects and  the Firewall connect so I am not using a DMZ port on the ASA. none...

wperez001 by Community Member
  • 2423 Views
  • 12 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card