Buy or Renew
Buy or Renew

Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

“Join

 
Labels

Forum Posts

Start a conversation

Resolved! Update ASA 5510 8.3(2)37 to 9.x

Hi,my 5510 is running 8.3(2)27 and i want to go to latest 9.x release to get the NSEL feature to provide periodic byte counters.Is it possible to go directly to 9.1.2 or do i have to make all the intermediate steps to 8.4 and 9.0.I saw some releases ...

xboessler by • Level 1
  • 967 Views
  • 3 replies
  • 0 Helpful votes

NAT Trickery on ASA 9.1

Hi, I am configuring a pair of 5525X's running 9.1, migrating from some 5520's running 8.2.5, so the NAT portion obviously going to be different.Topology is straight forward.  4 interfaces, Inside, Outside, DMZ1 and DMZ2.  For some reason, all 3 inte...

rrfield by • Level 1
  • 2072 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Is a reverse route needed?

User is going to place a "three leg" 5505 ASA on site's existing LAN.Two PCs, one in each firewall's DMZ and PCN network will use a NAT'ed IP address that is on site's LAN.Question is: will the site's core layer-3 device require a "reverse" route poi...

Resolved! ASA 5505 NAT failure

Good morning.  I am having some trouble setting up a new ASA 5505.  I finished the config and before I put the ASA into production I decided to run the packet tracer on the ASDM.  the test packets seemed to pass fine through my ACLs however keep gett...

Resolved! ASA 5525-X IPS AutoUpdate Fail

Hi,I am experiencing issues with the Auto Update feature for signature definitions for the 5525-X IPS module. I am using Cisco-Server auto-update with a proxy server (I am running the latest Engine Version).# sh verApplication Partition:Cisco Intrusi...

Resolved! ASA 5585-X SSP20 Context License

Hello Everyone,I Have two Firewalls 5585-X SSP20 work with HA in a single mode, i have a license key to work in multiple mode and enable 10 contexts, but, when i try to enable the new activation-key, i receive the message bellow:Validating activation...

SYN ACK error

Hi folks, hoping someone out there can point out why I am having a few difficulties on my network.We have 2 seperate internet connections protected by ASA Firewalls, one in our main datacenter and another in our DR datacenter. I have drawn a very sim...

ASA 5505 static nat error message

i would like to port forward an port 4500 on the outside interface to inside host but it shows the error message below.But if i add for port ftp and tftp without any problem.[ERROR] nat (inside,outside) 6 source static aruba interface service Aruba-4...

Resolved! ASA 5510 support ipsec site to site vpn by domain name way ?

dear  helper,           my issue :        our side  device is  Cisco asa 5510 SEC-BUN-K9 with a static ip , and the other side device is cisco RV180 vpn router without  static IP (dial-up),now  we plan to establish  IPSEC site to site vpn  between tw...

IPS Network Design

Trying to work out a way using "Firewall" and "IPS" on a stick type configs.My diagram: http://i.imgur.com/jJI7UcP.pngTheres a lot of unnecessary information missing but thats pretty much what I'm trying to do. So in the diagram: - Red lines are phys...

danieledu by • Level 1
  • 1296 Views
  • 2 replies
  • 0 Helpful votes
Load more
Review Cisco Networking for a $25 gift card