Network Security

Hello people,so i am setting a lab up and i am trying to go a little deeper on ASA default behavior. As far as i know by default ASA has a default access list permitting Any IP traffic from higher to lower security level interface. Default global ins...

Hi,With AnyConnect client, is there a way to avoid having to issue the same Active Directory credentials twice:one to auth AnyConnectone to login to Active DirectoryThanks.

Hi,I'm looking for a way to avoid doing 999 individual port address translations for ports in a range 1-999 for the same protocol. I'm not finding anything that asa code v9.11 will allow. I have the service objects defined but cannot find a way to ge...

Dear ExpertHello.Could you tell me about Cisco Configuration Professional. I'd like to try the IOS-IPS on Cisco2901-SEC/K9.I was search in CCO about Cisco Configuration Professional.The Cisco2901-SEC/K9 does not support SDM.But, The Cisco2901-SEC/K9 ...

ASA Version 9.1(1) !xlate per-session deny tcp any4 any4xlate per-session deny tcp any4 any6xlate per-session deny tcp any6 any4xlate per-session deny tcp any6 any6xlate per-session deny udp any4 any4 eq domainxlate per-session deny udp any4 any6 eq ...

Sorry for this question but my knowlege of switching and router is still growing.We have a HP Procurve 5412zl switch as our default  gateway for all our VLANs from there the traffic will be going to a  Cisco ASA 5515 and then to a Cisco 3800 Router t...

I have a website with very high hit rate which is protected by IPS. There've been complains about some dropped request so I've gone through IPS Event Viewer and I found many of this:evError: eventId=1321353761353146007  vendor=Cisco  severity=error  ...

Hi,I need to replace two small firewalls with an ASA. The ASA will need to support static PPPoE and dynamic PPPoE on different outside ports. I'm looking for an example of either configuration and confirmation that the ASA can handle this setup (not ...