Network Security

Quick question Is there a way to disable the Slot 1 interface from failover?  Specifically I have an ASA Active Standby config with AIP-10's in Slot 1.  I would like to keep the failover config but not monitor slot 1. Thanks,

Hi,Can we have PAT with nat and global statements for source natting a traffic from Lower security interface to Higher security? If nat & global can't achieve this, what are the Possibilities.merci,arun

I'm upgrading an ASA from 7.2.4 to 8.2.5 due to memory requirements for 8.3. My question is should I upgrade to 8.2.5 or to the interim for 8.2.5.  I would prefer not to upgrade to 8.2.5 and then hit the bug for the ASA leaving connections open and t...

Hi guys,i need to configure a ASA 5505 in transparent mode.learned from Internet, my configuration is :int e0/0 --- vlan 1---->nameif outsideint e0/4 --- vlan 2------> nameif insidegloable ip is 172.17.104.10 255.255.255.0http server enable http 172....

Hey Gurus, I just install two new acs v5.3 servers in two DCs. I want to setup a sync link or configuration between thetwo tacacs. how can i do it, please ?thanks,

I have been fighting this for longer than I would want to admit.  So any help would be greatly appreciatedBasically we need to connect a client via IPSEC to an ASA 5510 in Brazil and then using the same 5510 send that traffic source and destination N...

Hi,I have a network protected by a pair of ASA 5520, running 8.04.I do pretty much default dns inspection:policy-map type inspect dns preset_dns_map parameters  message-length maximum 1024policy-map global_policy class inspection_default  ...  inspec...

I received the following error on the FWSM. the IP in question is for a particular server which is part of a group servers and all rules in FWSM apply to the group servers. The user however only have problems accessing this 1 server and not all the s...

Got a small issue...  We recently changed ISPs from Verizon T1 to Comcast fiber.The only change made in the firewall was the outside IP address, gateway and mask.   No changes on the internal network or the interface.After a power cycle everything is...

I have a requirement to upgrade a a pair of active/passive FWSM's to get around a specific bug: the code is currently 3.1(1) and it's running in a 6509-e SUP-720-3B (12.2.(18)SFX8). In view of the available downloads the Safe Harbor logo seems to hav...