Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

so I look up ASA5505 licensing and for VLAN support see:3 (no trunking support)/20 (with trunking support)*I need 3 VLANs...inside, outside, and DMZ..but when it is creating the third (DMZ) it says I am only allowed to have 2 VLANs and can only creat...

slug420 by Level 1
  • 468 Views
  • 1 replies
  • 0 Helpful votes

I'm running two C6509 Chassis with FWSM and ACE module install on each chasiss.I have no problem with session into 1 FWSM and 2 ACE modules.But 1 FWSM module can't be access by session command.As I understand two FWSM module status is OK, and working...

Hi all,I have been trying to find this information somewhere with no luck.  I am new to the IPS modules with Cisco and need to install and configure two AIM-SSM-10 modules in my company's ASA 5520s.  What I would like to do is set them up in promiscu...

I have a VLAN 6 that is dedicated to a Partner organization (they share our bandwidth and schedule conference rooms with our Exchange).Question is how do I configure ACLs to direct ALL traffic to and from Partner, exception of accessing our Outlook W...

gmcvb by Level 1
  • 1003 Views
  • 2 replies
  • 0 Helpful votes

I'm having trouble configuring an ASA into a network solution.  We have a 501 with the outside interface on 10.24.10.1, the inside interface as 172.18.10.1, and a DMZ on 192.168.1.1. in the DMZ there is a HTTP/FTP/TFTP server connected to 192.168.1.2...

Famous_20 by Level 1
  • 3579 Views
  • 22 replies
  • 0 Helpful votes

Hi Everyone,On ASA  ASDM mode i config the ICMP rule any outside deny any IP any Mask.So basically i am denying ICMP on outiside interface of ASA from any IP address and subnet mask.After doing this here is results1> From ASA  ping to inside interfac...

mahesh18 by Level 6
  • 14785 Views
  • 8 replies
  • 0 Helpful votes

When setting up a subinterface for a VLAN...What do you set the security level at for the actual interface?As seen below, I've managed to do two different things.Intially I didn't know what I was doing...bet you hear that alot.  1)  Ethernet0/1 the a...

gmcvb by Level 1
  • 2403 Views
  • 3 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card