Network Security

Hello,We have an ASA 5510 which currently connects on its built in 100Mb ports to the Inside and Outside interfaces. We have just recently had an upgrade to our ISP and now recieve a 1Gb connection, we also have 1Gb switches inside our LAN. So we are...

Hi there,i have a problem with Routing on ASA 5505.Here is a brief explanation of the topology:DC Upstream IP: 77.246.165.141/30ASA 5505 Upstream to DC IP: 77.246.165.142/30Interface outside.There is a Cisco Switch connected to one of ASA Ethernet po...

Hi All,I am facing an issue with my IPS appliance.I am able to login to the device but it does not give me a prompt after that. It does not go beyond the NOTICE that comes up in the begining. It get stuck here:***NOTICE***This product contains crypto...

Hi,I am able to connect to any connect and able to access ssh telnet ftp http and https but not able to connect rdpRegards Thanveer "Everybody is genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing th...

Hi, I'm using cisoc-ASA-software version 8.4 and smartfilter. i'm getting "HTTP Error 403 - Forbidden" with below situation.1) when smartfilter blocks the client url request and sent a block page to the asa box, asa box should forward this to client ...

Hi Can some one help me with the above error in ASA 5520.

                   HiThe query i have, Is there any way to get management access to inside or management interface of ASA over Outside interface.  for example, if the there is head office and remote office connectivity over MPLS and the MPLS Ip is no...

Hello,Do you know how to configure PAT on Cisco ASA 5545x? please help me, thanks

Hello everyone. Have a HA pair of 5540's. Currently single network on all interfaces. Wanting to trunk our DMZ interface and create sub-interfaces. I am able to create the sub-interfaces and make them work no problem. I want to move our current DMZ c...

                 I have a closed network that is not connnected to the internet, just other sites that we want to communicate with.  We have a cisco router connected to the outside interface on an ASA5505 and a cisco router connected to the inside in...

I recently changed the username password & enable through ASDM for my asa5510. Now I can no longer access the 5510. It is currently a standby. Any suggestions? What are my options?

Hello security gurus!I'm wondering if there's any chance to make Content security module (CSC-SSM) work as IPS (AIP-SSM). It seems to me they are absolutely identical in terms of hardware. Is there any chance to make CSC-SSM boot with the flash from ...

I have a PIX506E that was resently reset and it has version PIX Version 7.1(2) .  It either uses some different commands or I am not using them correctly.PIX506E# show ip address insideSystem IP Address:Interface                Name                  ...

I have a Primary\Secondary LAN state firewall  pair.  The primary firewall is "Active", the secondary firewall is  "Standby Ready".  The running config has no "failover active" or "no  failover active" directives in place.  I want to manually fail ov...