My NAT policies have DNS translation enabled so that queries resolve to internal private IPs of servers when available. This works fine for PC users but I have noticed that Macs running Ventura and newer OS resolve the public IP. On the VLAN with t...
Forum Posts
Having a weird issue with anyconnect VPN. I am running 2 5545 ASAs in HA. If I am on my secondary ASA a specific vpn profile works just fine. However if I failover to my primary ASA, Anyconnect comes back with the following error. AnyConn...
Hi Experts,one of our clients are thinking of utilizing their ASA5515X device with FTD7.0.5 via FMC 7.0.5 and they want it for S2S VPN and RAVPN via cisco any connect only so basically all internet traffic will pass from their Sophos firewall.The Sop...
Hi Guys Can wireshark monitor/sees/detects encrypted traffic, how does this wireshark look like? thanks
Hi, To connect FPR3130 in HA, how many interfaces do we need to be configured Is 1 gig interface good enough or do we require two separate 1 gig interfaces, for stateful failover
hi,i'm configuring a new FPR 3100 with ASA OS.it's an ASA in multiple context mode and was doing some failover test and ping to the internet.it didn't failover to secondary after shutdown trunk switch port facing the ASA FW LAN and WAN. it only worke...
Hello All, I have configure IPsec VTI tunnel on ASA. i am try to configure NAT rule but interface not showing while adding nat statemen.
Resolved! FTD management over data interface
Hello, I need to pre-stage a Firepower 1010 and send it to one of our remote offices. This device will replace an old 5506-X with ASA software. The new device will run FTD software and will be managed by a FMC over the Internet using the datainterfac...
I was trying to allow an ip to reach only a specific URL and specific application with same ACP rule, But traffic could not match with this rule. for example : URL --> amazon.com , application --> whatsapp . So i tried to create a separate rule for U...
I realized that when I use the transport input ssh command, I can only ssh in from outside the network but I cannot ssh from inside the network.What can be the problem?
hi,i have a FPR 3100 with ASA version 9.18 and notice this "new" command line "no object-group-search access-control".saw this in a cisco doc but doesn't make too much sense.https://www.cisco.com/c/en/us/td/docs/security/asa/asa92/configuration/firew...
Resolved! Firepower 3110 ASA Disk
Hello. I installed Firepower 3110. I checked it had 900GB SSD, but I could check only 16GB in ASA. 16106127360 bytes total (14880862208 bytes free) Is it normal?
Hi,Does anyone know the OID of these value:VPN Session Summary---------------------------------------------------------------------------Active : Cumulative : Peak Concur : Inactive----------------------------------------------AnyConnect Client : 43 ...
We are constantly receiving the Health Monitoring message "AMP for Network Status - Successfully connected to cloud. FTD1: Number of files detected in traffic exceeds module threshold.We believe this is due to File Sharing between our hosts and our F...
Afternoon all,I've a need to populate an FMC 7.3.1.1 with the tags from Azure Service Tags https://www.microsoft.com/en-us/download/details.aspx?id=56519I'm trying to create a network object group which contains the IP addresses of all the entries fo...
