Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi all,Syslog show the next messageCall-home enviroment event critical memory usage (85-90) was dropped reason: INTERRUPTEDThe show command "shows memory" is correct.

I am having some trouble getting what I thought would be easy to work properly.  I have FWSM with multiple interfaces on it.  I need to create a source NAT for traffic from an outside interface(security level 75) to the inside interface interface(sec...

cbregeripr by • Community Member
  • 1404 Views
  • 3 replies
  • 0 Helpful votes

I am working at a client site today.  The IT Admin on the site asked me what the latest codes were for the ASA, and whether they were GD or ED.I explained to him that 8.4.x had not been out long (moving from 8.3.2) and that 8.4.2 was the latest.  He ...

Hi Team,We are facing the problem in ASDM 5.x creates duplicate network object groups in the configuration when PIX with software 7.0.7 is used.Audit report its showing below commands :asdm group SALES_ref dmz2 reference SALES object-group network SA...

Dear all,I' d like to have some support for a very-basic PIX firewall configuration.I 'm dealing with  PIX 515 's inside/outside/dmz zones.Inside hosts can ping inside interface , outside hosts outside interface and so on....I cannot ping outside int...

fattore73 by • Community Member
  • 4956 Views
  • 8 replies
  • 0 Helpful votes

I have a Comcast 50/20 connection going into ASA5510 inside connections are getting speeds of 2/7. If I connect laptop on outside my speeds are 49/9 but inside speeds are really really low? How come? Anyone with or had this problem?Sent from Cisco Te...

asfagan39 by • Community Member
  • 1194 Views
  • 2 replies
  • 0 Helpful votes

I have two ASA5540's in HA an Active/Standby mode. When I first started configuring the firewalls I had them connected to a Cat2950. The lights on the interfaces were Green/Green. Yesterday we moved them to there final resting place, I have them conn...

Hi,I needed to change the mask, not the ip address, of the outside interface of an 5510 running 8.2(3).Immediately afterwards I could establish ASDM but could not re-establish SSH. I tried the following:Zeroize the rsa key and generate a new oneCreat...

lcaruso by • Level 10
  • 1504 Views
  • 2 replies
  • 0 Helpful votes