Network Security

Hi,I have two ASA5510-BUN-K9 Fws and I am planning to buy 2 x L-ASA5510-SEC-PL= to put them in HA.I was wondering if the support contract that I curently have for the two ASAs is still valid or do I have to buy any support upgrade?Any help is much ap...

I am a beginner to ASA. I am trying to connect the ASA 5505 behind the netgear ADSL router which is getting dynamic IP address from the ISP. How to configure the ASA5505 outside interface for SSL VPN connectivity?Could anyone help me on this? Your he...

I am really new at this, so please forgive my ignorace. I've configured, to the best of my ability, a tunnel between my asa5505 and a firebox X using this guide, I had to feel my way through it since the ASDM in the guide is an older version:http://w...

the story is we configure the monitor interface  insidemonitor interface  outsidemonitor interface  partnerand save configuebut when i show run monitor-interfacethe configure do not show the 3 montitor interfaces, it only show other monitor interface...

I have 2 ASA5520's in failover pair.After failing over I cannot run ADSM on the secondary (now active device), I get "unable to launch device manager from [primary address]"I can ASDM to the primary device (now marked as "standby ready") on the failo...

On a Cisco ASA 5520.  I have 2 interfaces that are the same security level. I need hosts on 1 of these interfaces to be able to get to a specific IP and port on the other but I DON'T want to blanket enable 'same-security-traffic permit inter-interfac...

Dear All,I have a ASA5508 running in 8.3(2) and without enable NAT. If I do a static network address translation for a inside address. any Implict rule in xlate?In another words, what is the forwarding rule ASA choose while there is routing exist and...

Hi experts,My company uses a pair of 5510 ASAs as the gateway to Internet. I once configured policy-map to filter certain webpages (facebook, twitter, ...etc) and they work fine. However nowdays those websites all support HTTPS. In the https the URL ...

Dear *,I have a simple setup with a core switch and FWSM. From the FWSM I am able to ping from the inside interface (interface between FWSM and MSFC) of the FWSM to other vlan on the core switch and to the internet however when i source the ping from...

Hi,Please anyone let me know how to fix this issue?We got a replacement ASA 5580 from Cisco. We were not aware of PAK, Is there any other possible to generate Activation key?Can we generate PAK or Activation Key using SO (service order) number?

Please help me to configure ASA failover for 8.4.