Network Security

Has anyone come across any documentationdescribing how much power is available viathe two PoE enabled ports on the ASA 5505?The only documentation I can find just talksto the ASA 5505 having two PoE ports withlittle to no additional details about thi...

Hi,yes anybody an idea how to set the IPv6 nd managed-config-flag (like in IOS) with an ASA 8.4 ?We want to use an IPv6 DHCP Server for distributing DNS-Server Information to clients.If ipv6 nd ra is suppressed, the clients has no routing infomation ...

Hi,I am trying to port forward multiple ports on the same server using a single public IP address. The address is routable and not used elsewhere.My configuration is as follows:object network Layton host 10.0.22.52 object service Feed1 service tcp de...

HiWe've got the new IOS Content Filtering (provided by Trend Micro) setup and working mostly good on one of our remote routers, but it is only scanning/blocking HTTP content currently. When I add the HTTPS to the class-map, it complains;class-map ty...

This is my first time configuring a pix.  Once connected, I can ping through the pix using an ip address, but when it comes to connecting to alpha addresses, it fails.  Through the asdm logs, the pix does contact the DNS server.   I assume it's a DNS...

When I had the following static statement configured in my ASA, I was able to ping 10.102.10.13.static (inside,outside) 10.102.10.13 10.201.10.73 netmask 255.255.255.255Now that I've changed by static statements to what's shown below, I can no longer...

hi. I want to connect two switch to ips sensor. i configurate ips at interface inline pairs mode. swicthes interface ar configurated access or trunk mode.my question is that: is the vlan which pass througth the ips must be same at both switch at this...

Hi,Can somebody help me how IPS bypass interface module for 4200 is used? Is it that, when IPS appliance fails (no power, hardware failure), traffic can readily flow from outside interface to inside bypassing the IPS? Usually in inline placement, IPS...

Hi,We are in the process of upgrading the engine in our IPS and IDS devices. We've one IDS 4215 device in our environment which installed with E3 Engine(6.0(5)E3 signature S409).Currently we are using Engine version 6.0(5)E3 signature S409, now we ne...

Hi AllI have a AD server that needs to access to servers at a company out on the web. it an asa the protocol is ldap AD server 10.12.1.56 / 24External servers 206.123.45.122, 174.87.96.143ASA configurationaccess-list outside permit tcp host 206.123.4...

hi, I'm trying to configure an asa 5510 8.2(1)I have a range of pub ips 3*.108.234.145-150 >>> E0/0  3*.108.234.146 outside public      >>> E0/1  192.168.1.1  inside        >>> E0/2  192.168.3.1  dmz           would like to map dmz host 192.168.3.107...

I am having a problem configuring my ASA 5505 for NAT.Based on my research the following config should work.What am I missing. Chris