Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just in case this helps somebody else keep their remaining hair intact... Migrating an ATA 186 to CUCM 9.x requires the ATA to be running firmware ATA030204SCCP090202AI've just spent a few hectic hours trying to work out why I couldn't migrate some A...
Very quick question: I have a Unity 4.0 server. A license report shows: LICSubscribersMax: 225LICUMSubscribersMax: 190My failing memory seems to remember that this means that the system is licensed for 225 users, of which up to 190 can have UM enable...
HiQuick question which I haven't been able to find the answer to. What is the maximum number of contexts a pair of 5515Xs in HA mode can support? I know each 5515X can have a max of 5 contexts, but does that mean in HA mode a pair can support 10 with...
Hi Question says it all really... I have a VG224 SCCP integrated with CUCM 8.6. STCAPP controlling all of the FXS ports. All working fine. We can perform group pickup from an analog phone attached to an FXS port by doing **4XXXX (where XXX is the Pic...
Be grateful for some assistance with what I am trying to achieve - as there seems to be a total lack of documentation available on CCO that covers this! I have CUCM 8.6 and have registered to it some EX90s. Video point to point is working fine for in...
HiIn terms of accessing the VM, just press the messages key on the handset, press *, then enter the voicemail mailbox number and pin.Barry HeskSent from Cisco Technical Support Android App
Port g2/0/20 is receiving a BDPU inbound that was issued by itself (i.e the ISP switch stack) on another of its ports (i.e. there is a loop / redundant path). This is pretty much the only reason that a port will go into BLK state. IMHO it would be a ...
HiI've seen something similar when my DRS SFTP server wasn't running and the backups were failing. A restart of the Tomcat service seemed to fix it, rather than a reboot. Edit: Bizarre. Just seen this again on an 8.6(2) node this morning. DRF Master ...
And just as another thought... here's a left field guess. I reckon your old circuits were layer 2 tails (in the same VLAN) that terminate in your ISPs data centre, again on the same VLAN. This means that all devices in the same VLAN can always commun...
HiWhere I've seen ASA interfaces, particularly outside ones, showing as "failed" is where they can't actually communicate with each other. I'm not sure if its ICMP that is required between then, but I've certainly seen similar issues where the two AS...
