Network Security

HiI have a pix515 v6.3.3. Is it possible to configure dual ISP on two interfaces and have redundancy between them?regardsVipin

Dear All,Which part number for CSC-SSM with Plus License? i saw the part number for standard license.could you let me know?Best regards,

Dear Experts!!!I try to configure URL filtering in ASA (without CSC and external server).I know how to do HTTPS filtering. But here tell me its working with HTTPS or not???I am using IOS 8.4(2).With IOS 8.4.2 HTTPS filtering is supporting with CSC mo...

Hello,Resposting this since no replies were recieved for the earlier postI am just designing a solution where a FWSM consists of 2 contexts initially and has a shared outside interface pointing to the 6500 switch. There are 3 subnets connected to eac...

Hi,I have got a working 5505 ruinning 8.3.1 firmware and 6.3.1 ASDM.I have now purchased a second unit and ensured that both units are running the same firmware levels etc.I have via the ASDM created a backup of the working units configuration, and n...

Hi Team!I am after any advice previous experience with running ASA5585’s in active/standby across a local campus MPLS network. Supported design, leading practice etc.Specifically our design is that two ASA5585 are configured as active/standby through...

Hello Guys,Due to some reasons I am looking forward to use Dynamic Nat on a Router along with Overload command.ip nat pool IZone 83.X.164.68 83.X.164.127 netmask 255.255.255.192ip nat inside source list 100 pool IZone overloadaccess-list 100 permi  i...

dear alli have a asa 5520 and i want to download some tools to fast fast configure the IP QOS for BW for users and also soem tools that i can easly manage my asa so please give me any good tools to buy or donwload from net all the tools that are good...

Hi,I wonder whether anybody would be able to help. I need to setup a hairpining on our asa5505, with this conditions.- I have 4 networks in NATon the firewall inside, dmz, wifi, chit- the hairpining works well on "inside" network as we need- I need t...

Hello,I have attached a pdf of an example of a FWSM configuration with shared interfaces. Now what I dont get is (please refer to the link) http://www.cisco.com/en/US/docs/security/fwsm/fwsm32/configuration/guide/exampl_f.pdf. Also attached the linkI...