Hi,I have Cisco ASA and i configured for the Internet Access for the whole subnet but i need to configure the asa only for particular IP addresses not whole subnet. Can anyone tell me please how to configure?Thanks,
I have a CISCO ASA 5520 with ASA version 7.0(8) and ASDM version 5.0(8) I need to upgrade this to ASA Version 8 and ASDM Version 6.I know I am not supposed to upgrade directly to those versions. But do I have to upgrade to each available upgrade firs...
Hi EveryoneThere are number of signature that are available for use in IDS/IPS and we can select a signature if we want to generate alarm for the signature or not?I want to know what is the basis of selecting which signatures to enable and which sign...
I want to limit the Outbound FTP access from my internet LAN. Is there any way to limit the outbound FTP traffic, also i already have an extended ACL applied on my WAN interface. Please let me know how to limit the traffic .Thanks
hiif asa is not acting as dhcp server and clients behind the inside interface of firewall are having static ip add is it possible for the firewall to still assign the dns address considering that those dns servers are external to asa firewall . if ...
Hello Dears,Below is the Type of Upgrade Support what i have read.I want to upgrade from 8.0.(4) to 8.2.(4) Can i upgrade directly to 8.2.(4) or i have to upgrade first to 8.2.(1). As per the STEP 3 in (Active/Standby Failover Configuration) below w...
hii have 2 ques for qos featue in firewall. i have gone thru qos guide but was not able to figure out1) how can we control or limit the amount of bandwidth for a single host in both inbound and outbound direction . also if the same IP Address is gett...
Hello,The last week i have had a lot of UDP Flood attacks. I can't seem to figure out how i can stop them with my cisco asa 5505.The ports are all closed to the internal IP address (firewall is in transparent mode) accept for a view desired ports, bu...
Hello, but how would this router config be implemented on an ASA5510 8.3 version.ip nat inside source static tcp 172.18.10.84 3779 75.112.144.39 3779 extendable
Hello,I have an ASA5520, Can I configure transparent and routed firewall contexts (it has multi context license) and shared the same physical interface through 801.1q trunk? I know that FWSM support mix of transparent and routed firewall contexts. Bu...
Hi all,We bought a SA 540 Security Appliance to provide firewall protection for our servers.These servers run with public ip and there in no natting any where.I need to provide a layer of firewall protection with out changing the ip of these servers....
Can anyone explain why this happens?I configure the NAC agent to not bounce my port and to not refresh my IP address and when I'm logging in, the agent brings up a message saying "refreshing IP address".This causes the CAM to uncertify my device and ...
