Network Security

Hi,I have 2 problem in IPS-4255-K9. my network has 2 device of IPS-4255-K9 and each have different problemProblem no 1:My  IPS-4255-K9 after running for 1 hour or less than that starts to hang and all the traffic is blocked as it is inline mode.Probl...

Hi,Reading through the documentation recommendations and I would like to configure the following setup http://www.cisco.com/en/US/docs/security/asa/asa83/asdm63/configuration_guide/ha_overview.html#wp1095702 scenario 4, figure 58-6 but I can't find s...

I have to make several changes in the configuration due to our company switching Internet Service Providers.  Is it best to do a "show run" at the command line, then just copy/paste new config into the ASA?  Or is it better to run the "more system:ru...

Hello,Sorry for the basic question, but does anyone know how many ACL's is supported on a ASA5550?I have a client that is looking to move 7.200 ACL's from a Cisco 2800 router to a Cisco ASA5550 and would like to understand the below:-How many ACL's i...

ASA version 8.2I ran the IPsec wizard on my 5510 for remote access.  It would seem that by default ISAKMP is enabled on both the inside and outside interfaces.  Furthermore, my default dynamic crypto map is enabled on both the inside and outside inte...

Hi,Notifications are not being sent within ciscoworks 3.2. Trying to edit or add the SMTP credentials we receive the attached errors.I have added the NOS.log as well. How can we fix this?Thanks.

I'm install cisco work 2.2 and upgrade to Cisco work 2.6  butI'm not fine link download packet ciscoview for LMS 2.6  becouse customer can't see model in cisco view.I'm need download packet ciscoview router 12000 series , Router 2800 series and route...

Hello,We were getting a "TreeGenerator" error in NetConfig when trying to creat new jobs.  After come copious Googling, all we could think to do was reinit the RME db using "NMSROOT\bin\perl.exe NMSROOT\bin\dbRestoreOrig.pl dsn=rmeng dmprefix=RME"The...

Dear AllWe are running CiscoWorks LMS 2.6I have scheduled a backup in Common Services > Server > Admin > BackupMy question is, what does this backup actually do?Does it just backup the CW configuration?Or does it include data such as devices configur...

Hi,Does anyone know the OID for the "No Buffer" field in the output of "show interface" for 3845 router, running 12.4(15)T9?Thanks!David

Hi alli have installed cisco lms 3.2..i have got few problems in it..i have run a device discovery and discovered 12 devices in which 4 are reachable and remaining unreachable and i use cdp module for discoverythen i use ping sweeps for discovery and...

My question is on the NAC Guest Access Server:1) Is there documentation stating that the Active/Active support Bi-directional replication of the database and that only when initiating the secondary for the first time causes the secondary device to be...