Network Security

Hello Friends,I would like to know the following ASA and SSM-40 configuration meeting the standard configuration and please let me knowhow do i further do advance config to get out of this IPS module.Also I am using IME 6.2 tool to monitor ASA -SSM 4...

http://www.cisco.com/en/US/docs/security/asa/asa72/release/notes/asarn723.html#wp272663The ASA 5510 adaptive security appliance now has the security plus license to enable GE (Gigabit Ethernet) for port 0 and 1. If you upgrade the license from base t...

HI,I have following scenarion I wounder if someone could guide me. I have two servers in DMZ (on same subnet) both servers have static defined NAT entries on the firewall. I want to access one server from another using public IP but doesn't seem to w...

I have ASA5510 configured with two ether 0/0 and ether 0/1 redundant (full duplex) connected to   switch with 1000f Full duplex.  Problem was encountered when performing a scp from one zone going to another zone, the CPU would spike up to 50 percent ...

Hi,I  configure asa5520 with pppoe authentication. The service provider give a Static IP Address,but I test the asa can´t ping outside IP address and can´t open port from internet server in the inside.

Hi,I beleive that for establishing ssl vpn connection ,there is builtin certificate on the firewall.if i dont want to use that builtin certificate, can i use a external certificate here.Please Advise..Thanks

I am trying to use the ASDM to configure my ASA 5510, Each time I try yo lunch the interface at the browser, it got to a point is frozes, please see the attached for the screenshot. Please advice on how to use the ASDM to do the configuration.

I am having issues resolving dns and I am thinking it is my nat configuration.I have a cisco asa 5510 with these settingsOutside / inside / dmz1 / dmz2On my outside iface i have an ip of 192.168.1.### <--- this ip address goes to the ISAinside iface ...

OK .. I am have an odd issue I am unable to figure out. I have a new ASA 5520 that we implemented last week. I have the standard inside, DMZ, outside interfaces set at security levels of 100, 40 and 0 respectively. I have an ACL for inside traffice a...

1St configring Nac Ldap integrate with active derctoryi need steps in active directory to confuiger Ldap and integrate with active directorythanksahmed

I have a 2811 router with an IOS Firewall and I'm trying to enable smtp through. I've added smtp to the access lists but no joy. I even disabled the access lists and applied one with permit tcp any any and still no joy. I'm suspecting the ip inspect ...

Hello,Apologies if this has been covered before, I did a quick scan of forums here but might have missed a relevant post.  I am dealing with a 'base license' Cisco 5505 ASA 8.0(2) using ASDM 6.0(2).  I've noticed that normal background network traffi...