When configuring a pair of ASA devices in multiple context mode all documentation and text books I have read describes how to configure the high availability as active/active. Is it possible to configure multiple context ASA devices in active/standby...
Hello,I need some advice from the pros.I'm trying to setup a quarantine LAN as a second inside LAN for a Cisco ASA 5505. Traffic from the inside interface goes out without problem, for some reason outbound traffic from the quarantine interface is bl...
Hi All,I have problem with our ASA which is driving me crazy. ITSP is sending calls using SIP to our Public address. The ASA is configured to port forward the traffic to internal voice gateway/CCM , however the ASA seem to discard the packets even th...
I got ASA 5510 ver 8.2. Every time when I cold boot the ASA the startup-config not load. I have to get into the console and manually run the load command to startup. What do I need to make it the startup-config automatic load?Thanks,Nelson
I am having one of those moments where my brain is imploding....I have an ASA running 8.x.Inside = 100DMZ = 30Outside = 0Am I correct in saying....All traffic from a higher security zone to a lower security zone is allowed by default. So traffic from...
Good Morning All,I am sure you have all heard of the upside-down-ternet by now. I was wondering if there was a way to do this with the ASA 5510. We were looking to either flip the images or replace all images with a picture of our own choosing. If yo...
hi! how do i do a graceful shutdown of my fwsm and Ace module in my 6509?Thx
If I have an ACL allowing port 80 traffic through the outside interface to a server on a DMZ, and an ACL with a DENY STATEMENT for all traffic leaving the DMZ on the DMZ interface, will stateful inspection allow the outbound connections from the DMZ ...
Hi,I have a query about Active/Active failover in ASA.Is IPS module supported in active/active failover ?BR/Abhay
I noticed that the software for the E4 engine update has been posted for all IPS devices, but no matching signatures (yet). Also, I see that the IPS updates for MARS now have an update for S480 available, but no matching signatures for IPS.Is this j...
HelloPlease Clarify me,does the IPS stops Virus/Malware at the Edge,Like the ProxyAV or Fortinet or Even CSC-SSMThanks
Hi All,I just had a Cisco ASA 5505 and I am trying to configure it with a inside and outside interface. The inside network will just have one web server but I am having problems getting http connections out/in from the web server as the implicit deny...
Hi,I have a new cisco ASA 5510 that i have to configure for the first time. After setting my terminal emulator for 9600 baud, 8 data bits, no parity, 1 stop bit, no flow control and connecting the appliance to my Pc with a console cable, i powered it...
All,I have the following configuration snippet on my Cisco 881W that I cant make heads or tails of:class-map type inspect match-any ccp-cls-insp-traffic match protocol cuseeme match protocol dns match protocol ftp match protocol h323 match protocol h...
Dears,Can I shutdown all unused ports at Cisco switches by Netconfig or other tool at Cisco Works managment too?I have 300 LAN switches and I need to block all unused ports automatically.Many thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 09-22-2026 04:13 PM | ||
| 08-25-2026 06:22 PM | ||
| 08-24-2026 12:26 AM | ||
| 08-20-2026 05:54 AM | ||
| 08-19-2026 07:59 AM |
| User | Count |
|---|---|
| 4 | |
| 2 | |
| 1 | |
| 1 | |
| 1 |
