Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi We have LAN/WAN Infrastructure. We are using Cisco ASA 5510 .One of our branch office they have 30 computers in office room and 5 computers in lobby .All computers in LAN has same series IP (10.10.70.1/24)and they able to go internet and intranet ...

aminulnt by Level 2
  • 1262 Views
  • 4 replies
  • 0 Helpful votes

Hello,Guys I have been working with 3 IPS 2 4260 and a 4270 since yesterday I have noticed that the Inspection LOAD is RED. On the 4260 the inspection load is. SJDetec1# sh statistics virtual-sensor | inc Load         Processing Load Percentage = 99 ...

This is a pretty dumb question, and may have already the answer, but none the less... Does it matter the IP address i assign to the IPS module?  I mean of course it is an IP address on the inside but does it matter if it is a part of the normal data ...

bob.bhakta by Community Member
  • 1389 Views
  • 2 replies
  • 0 Helpful votes

Hi all,I have PIX firewall and i configured IPSEC VPN for external users to use IP communicator as their office phones outside the company.When user use the communicator outside the company, he hear any voice call and the called party hear him even t...

Hi every one.we have a router 7613 with two configured and running IDSM2's in slot 3 and 4.for some reason i changed one of my idsm2's slot and put it in slot 2.now when i reload my 7613 and when idsm2 comes back online when i try to login to idsm2,n...

Resolved! nat configuration

My ASA has an existing overloaded nat in place for all the connections going out.like nat ( inside ) 1 0.0.0.0 0.0.0.0 i need to configure a seperate nat for outgoing translation with a set of ip's.local ip's are 192.168.100.1 to 192.168.100.3 & it i...

suthomas1 by Level 7
  • 1246 Views
  • 5 replies
  • 0 Helpful votes

We have an ASA 5510 and have it set to enable Threat Detection and "Shun hosts detected by scanning threat". I attached a screenshot of the ASDM. Once a month we send out a video to our member firms and one firm will continually get shunned. It happe...

Hello,I have a LAN IDSM in promiscusous mode wherre I'm seing too much of the below alerts, I've researched it and found out that it should be stopped! since it is a high severity alert!! however I guess summarization is preventing me from knowing th...