Network Security

I was wondering if I could get a bit of configuration advice to add a honeypot on my 5505 (10 user base license) in my home environment.Currently I have default vlans 1 and 2 setup for inside and outside. I would like to set up vlan 3 with restricted...

Dear allMy organization has a leaased line internet that is connected to router , then asa 5510 .From ASA 5510 it is distributed to LAN.NATING is done in ASA.The IP range is 120.125.51.128/27.The router interface IP is 120.125.51.129.The out side int...

I've run into a weird problem. I have an ASA5505 with a very slow Internet connection that acts as an EasyVPN client. I want to upgrade the software image on it but given the speed of the Internet connection, it's going to take about 2 hours. Every t...

I think I know the answer to this but I want to run it by the forum.I have an office that is on DSL with the highest speed available. The problem is that it is not fast enough. Currently, the one DSL has a site to site VPN tunnel to our HQ and works ...

I have a feeling I'm trying to bypass the primary functionality of an ASA..but might as well pose the questions.I've got an existing home-office lab network that relies on a Netscreen device as the firewall, using it to map a variety of lab servers/s...

Hello,I have an ASA 5510. Our office does not operate 24hrs, so we shutdown every device at the day end and turn them on the next morning.The ASA was working fine till yesterday evening, but today when we powered it on, it does not bootup nor does it...

We just got this question on our CSC Facebook fanpage http://www.facebook.com/#!/CiscoSupportCommunity?ref=sgmhow to configure a sonicwall firewall ....can  any bdy help me.....i am just started cisco

Does Cisco have a committed feature to support IPv6 on the management interface of the IPS sensor OS?If so, what release should we expect to see that in, and when might that be released?Will IPv6 be supported on all the existing IPS sensors? If not, ...

Hi,I have installed one sa540 in customer place.Customer asked to create separate vlans.sa540 is running the current version.Now i have created vlan and intervlan is enable is the firewall.i am able to ping the intereface ip of different vlans but i ...

We had an ASA5520 reboot this morning and come back as Secondary with no problems. I wonder if there is a crashinfo file, or some other record as to why this device rebooted?  Thanks in advance for your help!