Network Security

Hi,Is there any way we can keep L2L VPN connection for few days?I have a customer has one HQ office and few remote telworker. Every time when telworker want to talk to each other, they have to ping each other to get VPN tunnel up, but the tunnel only...

Need to access ASA 5505 via SSH on two outside interfaces. I can access one using SSH but am unable to access the other interface with SSH. I've set up SSH access on both with the appropriate source IP networks but still no success.

I have an ASA running 8.0(3). I have two syslog servers defined. Is there a way to send two different level messages to two different syslog servers? I see the "logging class"/"logging list" commands to alter differnet level messages to seperate outp...

We just recently upgraded the CSC module from version 6.2.1599.6 to 6.3.1172.0. It was running fine, but ever since then we've been getting occasional web timeouts and slow loading. No other config changes have been made.In my syslog I'm seeing the...

Hi All, we have a 7609 chassis where we have installed the FWSM module and IPsec VPN module.we would like to configure a Site to Site VPN. how do we do that now ? Below is the VLAN interface configuration (outside)on the fwsminterface Vlan601 descri...

I have a web server that is NAT'd to an public IP. We are migrating to a new public IP address block. We have a DNS domain pointing to this old public IP. I can't NAT the server to both IPs so when I make the DNS/NAT change it can't work on both ...

HiI have a VPN between 2 locations and I can see the servers are communicating. Can ping between the servers all the time. however the connection times out after some time. There is no specific time it times out. The data is continuous and the other ...

Hi, Is there any difference between ASDM logging and 'show logg'. Thanks.

Hi, I have installed ASA 5520, and using Unified communication. Network config is:CM---3845---ASA-5520---Internet---SIP-proxyCan some one help to allow the SIP traffic on ASA, the Access list syntax!we use NAT on ASA! So 10.x.x.1 is the private addre...

Hi!I have a point to point network for a branch to my head office. I need to connect it to my Internal Network Switch 3750 port. I have a spare PIX 515E that is not in use. My question is that what will be better choice both security wise and speed w...

Hi, Can I use SDM or similar to administer PIX 506E firewall, I need to change some IP addresses.ThanksS

Can you have an Active ASA in your primary location and a Standby ASA in your backup location if the connection between them is sufficient?,, Can both the state and heartbeat connections both go through a switch?