Network Security

I want to access DMZ server by IP invalid to Outside with pix515e with IOS version 8.01

I've upgraded from 7.0.(4)4 to 8.0.4(4) with intermediary upgrade of 7.2.4 however both upgrades were done in monitor mode before a reload. If 8.0.4(4) is running fine in RAM will it be OK to copy this image to flash, set boot system file and save c...

internet security 90dmz security 50now my application on dmzso now i want to access application bye intranet at that time i got error is deny x.x.x.x to intranet x.x.x.x access_roup ntranet_access_in

I am getting ready to upgrade from v6.1 to v7.0. I noticed in my IPS Active Update Bulletin e-mails that signatures for are platform 5.x and 6.x. What about v7? Should I assume the signatures for v6 are the same for v7?

We have a site to site VPN using a pair of PIX 515's in the primary site that works fine almost all the time. Once in a while the remote side cannot access anything in the primary site and it seems that doing a clear crypto and clearing the tunnel fi...

Hey,i am facing a problem when i add a 2960 switch to the NAC manager switches. I checked the log and i found the following error: cisco SNMP trap event is received from switch [172.22.1.46] which is NOT in our databaseNote that i was using the ios: ...

Received follow error after service module was restarted:From diagnostics event - 07/13 13:08:10.573 E [2] komodo_plus_lb_pc_port[2/7]: check_ether_packet failed (err-code 43)From sh log -Jul 13 13:04:34: SP: The PC in slot 2 is shutting down. Pl...

I have 2 5540 ASA in an Active / Standy setup. The Active firewall has a packet shaper sitting between it and the inside LAN. When I reboot the Packet shaper the FWs failover. I have the default timeings for failover 1 second hello 15 seconds keepali...

I need to configure the following rule and need help to configure a ACL:Server (192.168.254.22)is in the DMZFrom server Port 1521 open only to users inside the xyz domain (not externalusers)From Server Port 80 open to any host (internal and external)...

I have an issue occuring that I've not saw before.I have a Global NAT configured. I have a single host that continues to display with 2 translation (both the same). the translation is correct, but I cannot communicate with the box. what happens is...

hiI'm reviewing the situation next three traffic zones outside, inside, DMZ,service-policy xxxx-policy interface outsideservice-policy xxxx-policy interface insideservice-policy xxxx-policy interface dmz_stgoand I need to lower the level of examinati...

I have an IPS-4215 that I am putting online for the first time. I am upgrading the signature file. My question is this: what else do I need to download to monitor this device once it is running?

Hi, What are the steps to enable SDEE on AIP-SSM in Cisco ASA. Thanks.

Hi, recently i connected in the network a failover system ASA 5540 [Version 7.2(2)] (active/standby). I have added the command login banner and I had already enabled ssh version 2. Unfortunately when i make an ssh session to ASAs the banner does not ...