Network Security

I've tried to avoid Vista, but unfortunately I have a couple customers using it. I get two errors when trying to install the Anyconnect client when they access the SSL vpn site. "The VPN Client agent was unable to create the interprocess communicatio...

I have Cisco VPN Client ver 4.05. I connect to internet via proxy. How can i access vpn via proxy. I dont find any access in vpn client where i can configure proxy in client.

When i connect to my VPN server as a remote i got erroe is deny udp source indise X.X.X.X/32771 dst internet time /4321 by access-group "inside"for this error what i do ?

I have got Webvpn (ASA5510) working with WM6.1 and it connects fine, however when I try to access a bookmarked Citrix Web interface page it will not load. Any help appreciated.

Hi Everyone,I'm trying to make an REXEC connection to a device outside of our network in order to run an xterm window.However, even after configuring the ASA to allow outbound connections to the remote IP address (in the ACL) this still fails, I see ...

Hi,I have ASA5510 whose INSIDE interface is connected to a Cisco Cat 2960G switch (L2),Now I have 3 VLAN configured in the Cisco2960G,and a TRUNK port is connected to a ASA5510 Inside interface,that inside interface is configured as a TRUNK,which is ...

Dear Security Experts,I am facing a issue in FWSM. I couldnt even get a clue why the nameif command is not working in Fwsm. All the required commands are done in CoreSwitch (Vlan group etc) and i can see the vlan also in fwsm.please gimme some hint t...

Hello everybodyI am new to ASA configuration and I need some advice.I have an ASA IPSEC VPN Hub and Spoke configuration with fixed IP@ (outside) on the central ASA and dynamic IP@ on the spokes.I have now a new ISP link connected to my central ASA (n...

Randomly some logging messages are missing from loggging buffer in FWSM.FWSM Ver. 3.1(11)Logging queue seems to be ok:XXX/act# sh logging queue Logging Queue length limit : 2024 msg(s) 0 msg(s) discarded due to queue overflow 0 msg(s) discarded due t...

After updating to S394 get the following erroridm error connecting to sensor "failed to create sensorhave tried rebooting the sensor, no change.Am able to log in through command line.

CAn anyone provide guide/reference/link for Deploting IDS in an enterprise network including Deployment guideline in Data centre as well as in Extranet and remote Locations.Thanks in advance.

Hi,I have on my company two Vlan (192.168.1.0/24 and 192.168.2.0/24)but without switch layer 3 so without connection them.Now, I need to give application Citrix installed on a host 192.168.2.8 at some client from network 192.168.1.0.So I think to dep...