Network Security

Hi,I have a 3000 series VPN Concentrator and I am trying to get the auto-update feature to update and install the VPN Client Silently/Unattended.-MSI install-previous version: 5.0.03.0350-new version: 5.0.04.0300I've got auto-update to notify and got...

Is it at all possible to have two or more NAT translations to external IP addresses that translate to a single internal IP address on an ASA 5510? For example can 1.1.1.1 and 1.1.10.1 translate to the same internal IP address.

Is there a specific upgrade path from PIX 7.0(2) to PIX 8.0(4)

Hi, after the CSA 6.0.0.220 upgrade I have some old kits to delete and some new kits to create for the actual groups.I'd like to know all the post-upgrade operations necessarythanks in advance

Hi,After the port taken into control under the profile & bounced it shoud change the vlan to the authentication vlan which is not happening. I have configured everythng as per best of my knoldge.Can anyone pls guide me if anywhere I am missing someth...

Hey,i have a little prob in my test-lab.The Lab: pc -> switch1 -> asa -> switch2 -> access pointI configured the devices and after they booted, i can ping all devices from the Pc ( AP, FW, Switch2 behind the asa )After about 20 Pings i get ping timeo...

HiI have received 7 ASA (1*5510 and 6*5505) with the PAK associated for security plus licenses.I connected to the cisco web site to generate the activation keys.I received 5 activation keys by email but 2 are still missing and now I cannot use the PA...

Here is the deal. We dug up an old Cisco PIX 501 that has been previously activated and used sometime way back when. I looked through the config and noticed a lot of commands that vary from what I've learned on the CCNA track. I saved the old config ...

Hi guys,what is the difference between static nat & alias?is it that in alias ip addresses can be in any interface?just i cant no understand when to use alias command? and why?Regards,

Is there a way I can allow connection from inside the firewall to one of my public IP which has a static NAT?I connect out from internal and want to connect via port 80 external on a second IP mapped back to an internal address? Is it just a case tha...

Hi,I want to use our SNMP server to monitor our IPS modules CPU and Memory, does anyone knw the OID(s) I need to use?Thanks

Dear all,I am facing strange problem with 6500 IDS module.Management port of IDSM is up and Data port 2 Operational Mode: down.When i check traffic on this port it is one way only.I can able to ping IDSM management IP but when i try to telnet it give...

Hi,I have two 6509 each with FWSM module. we will configure this in active/standby. We want to configure 10 vlans for inside and 5 vlan for outside will connect to my mpls. internet gateway cloud. I don't want any restriction between my inside vlans ...