Network Security

ASA5510, v8.0(4)I've set up sla monitor per Cisco Document ID: 70559This morning it failed over to the backup link like it should.However, when the primary ISP link was restored it was not reinstalled as the primary default-route. I disconnected bot...

So I've got a hub and spoke config setup between three sites (reston, DC, and NY with DC being the middle site btwn the other two) currently up and operational (thanks, acomiskey). All is good to go, but I wanted to lock down some ports/services and ...

Hi All,Recently, I just migrated FWSM from ver2 to ver4.0.3. I notice it takes very long to compile automaticcaly after editing rules.Is there any alternate way to speed up the process?cheers

I have been allocated two non-contiguoius subnets by the ISP, am I right that there is no way to support two subnets on an outside ( e0 ) interface ?

I don't think I'll need nat enabled, but wanted to double check:My ASA that I'm configuring is behind another device that actually NATs the traffic for us. I have a public address assigned to my outside interface on the ASA and a private on the insid...

Hello All,We are trying to upgrade the signature of an ASA-SSM-10 module from S372 to S388 and we are getting the same error: Error: execUpgradeSoftware : Target system does not have a valid license to process the config with the version S361.1.Pleas...

Hi All,This one has really got me scracthing my head. Imagine three interfaces INSIDE, OUTSIDE and DMZ at security levels 100, 10 and 100.Access rules are in place to permit traffic from INSIDE to DMZ and also INSIDE to OUTSIDE. There is also a 10.0....

folkscan an asa have two separate external interfaces, each using a different NAT, both connected to the same isp routeri need to route traffic from my internal network through the asa and filter it based on destination address - all for http traffi...

HelloHave An ASA with the following statements:ASA Version 7.2(4)9 route Inside 10.1.1.50 255.255.255.255 Y.Y.Y.Y 1route Inside 10.1.1.51 255.255.255.255 Y.Y.Y.Y 1route Outside 10.1.0.0 255.255.0.0 X.X.X.X 1Made a Change and only add The rule:route O...

I am a contractor with a client that is upgrading 7 Cisco ASA 5505's from 10-user license(s) to 50-user license(s). I have never run into a client of mine who didn't purchase an unlimited licensed Cisco product and have no clue what the procedure is...