Network Security

Dear Team,what is the difference between the normal authentication we use (when authenticating VPN client with VPN server) as compared to SUA/IUA

I have 5510's running ASA7.2 @ my HQ and remote sites running 5505's with L2L or EasyVPN connections. I upgraded my home EasyVPN 5505 to ASA 8.0. The transition was seamless except that I can now only access the networks that are being tunneled tha...

I've tried everything out there, but I have no luck. I am using firefox and tried various configurations for setting up PDM, but each time I access it in Firefox, I get "Cannot communicate securely with peer: no common encryption algorithm(s). (Error...

I currently have a Catalyst 4510e doing intervlan routing between multiple Vlans. I want to install an ASA 5540 into the mix which will have a DMZ and another firewalled PCI segment, that is protected by the ASA. Is there a Cisco article that descr...

Rookie here so please forgive me as I have no Cisco knowledge.At my work we have a site to site VPN and the status is up. I can ping their private ip and the other end can ping my server. However when he tries to RDP to my server he is unable to. ...

Hello there, we just swapped out our Pix 525's for some nice, new, shiny ASA 5550's. I must say that I like the ASA's much more :-)One problem that I see is that we've started to receive overruns on the fiber interfaces. In my past experiences these ...

Per cisco documentation:"IP Verify Reverse-PathEgress filtering verifies that packets destined for hosts outside the managed domain have IP source addresses verifiable by routes in the enforcing entity's local routing table. If an exiting packet does...

Hi,I'm trying to ping an IP on the subnet I've created 10.1.101.1/24 from network 10.0.0.0/16. I've pasted in output from packet tracer below. Am I missing something? I don't have any ACL's applied to all interfaces. ASA# packet-tracer input inside i...

Hi ,I have ASA5520 and module ASA-SSM 10.When i use the asdm ,I can open GUI for ASA main menu and IPS.But ASA main menu is working fine,but when i click the IPS icon,its not connecting the ASA-SSM-Module.I'am geting some error.Unable to Access the I...

I upgraded IOS on PIX 515E from ASA image 7.2(4) to PIX image 8.0(4)16. NTP statement disappeared. I tried to add NTP statement back, but got the following error messages:Firewall(config)# ntp server 10.3.1.3 vPif_getVpif: bad vPifNum(0xffff) from ...

Hi,I have a PIX 515 E,it is working fine all the ways,but suddenly the entire LAN users ar enot able to access the INTERNET,but the same time mails are going and coming without any problem.VPN tunnels are established but throgh the tunnels applicati...

HiHere's a gif in attachment that will help you to figure out what I'm trying to say.I plan to secure 3-tier architecture with firewall that I already have. It's an ASA 5520 and I transformed my Management interface into an Ethernet Interface so as ...

Hi I need to ask a simple question, I have a site to site VPN, and it is working properly, If i want to add an access-list on the outside interface of the firewall for the incoming traffic, does it affect the VPN Traffic? i have to permit anything re...