Network Security

I have the firewall and it is working perfectly. I have not configured the IPS Module yet. I have IPSEC VPN also configured for the remote offices and it is working perfectly.I want to enable IPS Module in the firewall. I want to know how to pass the...

Hi ,I am in the process of upgrading 2 nos PIX515E 6.3(3) [one is having UNRESTRICTED LICENSE and the other one is having FAILOVER License] to 7.0,While upgrading is it necessary to have new license key?Please claify and help me.Best Regards,

HiI am getting this error in ASA Firewall 106020: Deny IP teardrop fragment (size = 40, offset = 0)from 192.168.2.112 to 172.16.100.5.Can somebody please help me out in this regard

I am aware that the FWSM 3.1 and up can support both routed and transparent modes in different context. My question is can these modes be run within the same context?

Hi,I have a Site A and Site B at different geographical location,which are connected using Routers through leased line.Now at both the location behind the router I have connected a Cisco PIX 515E firewall,behind the firewall I haveconnected L2 switch...

We have pix 515e (6.3)and want to pass traffice between two devices on the basis of their mac addresses connecting to inside and outside interface of PIX.Is it possible?

1. How the standby unit will detect failover in following two cases(if the actual primary unit has been powered Off due to some reason 1. If we are using a crossover cable to connect the active and standby units 2. If we are connecting active and sta...

I have this command in my configip route 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx 1but gateway of last resort was not set, and this route is not show when I do "sho route" command.I try remove it and add it again, no luck.Thank you for your help.

Just a heads-up!Hey guys just installed Java 6 update 11 and this breaks ADSM v6.1(1) running on a PIX 515 running 8.0(3). Gives you a unconnected sockets not implemented, and then closes! Just removed it and it'll start working again. I verifed this...

The ASA 5505 comes with a default IP of 192.168.1.1. I need 192.168.10.1. I can change it with Telnet, with https Applet and with https Startup Wizard, but then I am locked out until I go back in with Telnet and put it back to 192.168.1.1.When I Show...

I am looking for method to automate backing up FWSM configuration. Our FWSMs have more than four contexts and I am looking for backing up all of them. Although I have read old posts on this in netpro but couldn't come on some concrete conclusion and ...

Hello,I have the ASA configured and everything is working fine. But whenever I add a static policy nat, it stops my computer to communicate on port 3101 (TCP). When I take it out everything works fine. I would like to translate one local address to m...

Hi all I have got two ISP Connections and With PIX 515 i just want to load balance my outgoing traffic to internet.Does PIX Support load balancing Can we have Two default routes to two Routers in PIX 515?