Network Security

Hi,I have a remote site at IP address xx.8.140.226 currently using a Linksys to VPN to an ASA 5505 (at IP xx.60.101.154), in a lan to lan connection. I wanted to replace the Linksys at the remote site (xx.8.140.226)with a Cisco Secure Router 520. I u...

Good day,I am trying to find config. example to enable inline monitoring on the AIM card.AIM-IPS-K9 with 2811Also, I would like to bypass all the VoIP traffic from traversing the AIM card. I think this can be accomplished with an access list on the G...

Hi to all, I configured on a ASA5510 the interface g0 as outside with sec level 0, g1 as dmz with sec level 50 and g2 as inside with sec level 100.using ASDM I configure dinamic NAT and some static NAT between inside and outside and all works fine. B...

I upgraded an asa5510 fw to asa version 8.0.4 and asdm to version 6.1.3. Since the asdm upgrade I am able to login to asdm, but when I click on the "Configuration" tab I receive the following error, "You are authorized only Home and Monitoring Views....

Hello,I known that I cannot use telnet into the fwsm from Outside, except if you are coming via a IPSEC tunnel, but in my case I don't need to use an outside interface.My fwsm context is only local with 4 interfaces and i want to telnet from all inte...

Attached output from firewallshow processes cpu-hog MAXHOG NUMHOG LASTHOG Process-------------- --------------- --------------- --------- 4100 3 4100 ssm4ge_cfg_poll_threadFWASA01# changeto context ASA01FWASA01/ASA01# sh cpuCPU utilization for 5 seco...

I'm running into a problem with a pair of ASAs using the same MAC addr. This confuses the heck out of a third-party network management tool that apparently uses MAC addr as a unique device ID, so it keeps thinking one is the other. The two ASAs are n...

OK im new to ASA im officially going to training in 4 weeks but would like to get familiar with the unit, we got 2 x 5510 and mars. Now im read everything i think about getting the ASDM up, like go to https://192.168.1.1 well i attempt but i get no r...

Is there a special command to enable/forward the necessary ports for FTPS?

Ok- I am confused and I hate it when that happens!When I look at our ASA CLI with a "sho ipsec SA summary" I get this:Current IPSec SA's: IPSec : 54 IPSec over UDP : 702 IPSec over NAT-T : 64 IPSec over TCP : 908IPSec VPN LB : 0Total : 1728However, a...

Hi,I have some questions on ASA.1°/ How to enable the SSH connection on OUTSIDE interface? I want that a specific host can connect on ASA to the OUTSIDE interface.2°/ With this command access-list outside_access_in extended permit icmp host 172.16....

I have a Cisco PIX 506e which I would like to log all outbound SMTP traffic down to internal IP address. I have a rogue spammer on my network which I would like to track down. I am not to familar with the CLI and prefer to work with the PDM if possib...