Network Security

If I have a L2L VPN tunnel configured and it is not coming up,What is the sequence of the tunnel coming up?For example, at what point should I see the access-lists for interesting traffic getting hits in the process?If the tunnel does not succesfully...

Hello,I'm running a NAC solution (L2 OOB VG). I'm fine tuning the CCA section configuration on the CAM. I've selected 'audit' for my enforce type in the Requirements section, because I want to see all the reports whether my users are certified or not...

I have 2 ASA 5520 boxes setup with 2 ISP each, and i fail to get it to failover the tunnels properly, since i cant use set connection type, because that only works if one of the sites have 2 ISP and not both, could anyone recommend what to do ?Regard...

Dear Allcan anybody provide me ios image for pix firewall, i need it it very badly

Help me to get the exact OID from rttMonMIB to calculate the delay,jitter & packet loss.Thanks

hi,i have got my remote VPN configure on my asa 5520.My vpn is binded my with isp connection. Now i have got another connection from another isp. I want one VPN profile configuration to work with both isp interfaces. Basically my VPN user will have o...

Hi!I have PIX 515E Version 6.3(4) which i need to configure using PDM Ver 3.0(2). I am able to open https://192.168.1.1/startup.html or https://192.168.1.1 from IE but after that it stops on the loading screen. I have already installed and enabled JA...

Does anyone have or can any one direct me to where I can get more inforamtion on 4GE bypass interface card?The only documentation I can find on this card from cisco is the following linkhttp://www.cisco.com/en/US/docs/security/ips/5.1/installation/gu...

Hi I am Newbee to ASA configuration. recently we brought one ASA5505 i tried my level best to configure the ASA we are getiing PPPOE IP from ISP. after PC are not able to browse. from ASA i am able to ping the outside network. can any one please help...

Hello,We have a PIX 506 firewall and I need to allow a specific IP address, 141.157.129.77 to access a server inside the LAN on port #1999. I created a public IP address for the server but I am not so sure if the following command is correct. access-...

Is solaris 10 supported for CSA software, I can only see solaris 8 and 9 on the tech specs

I'm trying to create a mesh network using dmvpn, and everything works great until I put an ASA5520 in front of the hub router (2801). The ASA initially blocked all communication to the spokes, but after browsing the forms I found the following comman...

Hi,I have local digital voice server which is Siemens hi-path 3000.and from this local site i have configured IPSec Site-to-Site VPN to a remote site, ASA from my local side and Cisco 2811 with IOS firewall.Now, the remote IP phones is connected and ...

Can somebody please send me a known working snippet of ASA config to support a DMVPN hub NAT'd behind an ASA. I tried for 2 days even with TAC and I was finally forced to put my DMVPN Hub out on the Internet with the IOS FW.Basically the issue I was ...