Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi,I'm running a DHCP server in the inside interface. I configured the IP address of the interface inside as a DNS server (DHCP setup) but i can not resolve any domain. I tried to use the Internet with my ISP DNS and everything works well.The unit ac...

cesarpuga by Level 1
  • 536 Views
  • 3 replies
  • 0 Helpful votes

HelloIn my network we have upgraded the FWSM software from 2.3 to 3.2. After the upgrade we have encountered the following problem. We have an application that is using SQL-net protocol and is passing our FWSM in transparent mode. The problem is that...

Hi to all,i need to configure a subinterface as inside and i want to know if i need to configure a vlan in order to make it work or if is possible to avoid the vlan.

Resolved! what Firewall

Hi everyone, I need to know which Cisco's firewall can work with a large traffic and provides a ethernet ports and memory expasion. Or one that come with a good number of ethernet ports and memory.The traffic is from 30 computers send 1 GB of data ea...

Resolved! PIX 506E PROBLEM

I'm at job configuring a Cisco PIX 506E, and I have a problem.The outside interface can't reach the router wich bring the local net to the internet. I don't want anything by now but to reach the internet and do some port forwarding for some local ser...

godzilla0 by Level 1
  • 5238 Views
  • 38 replies
  • 0 Helpful votes

Hi,Can anybody send me a lab with a scenario for IPS using AIP SSM 10 and and if they could be for both CLI as well as by using ASDM. Also, when I was trying to access IPS using ASDM, I was getting an error message "Error connecting to sensor. Failed...

Why are there no vendor provided signatures that detect SQL injection reconnaissance? I recently did an internal pen test and it reminded me again of this deficiency. I've been meaning to write my own for the longest time, but frankly...why should I...

mhellman by Level 7
  • 1833 Views
  • 11 replies
  • 0 Helpful votes

Hello,Does the ASA5510 >ASA5510-SEC-BUN-K9 Support Failover?Was wondering about this:Not supported; Active/Active and Active/ Standby**** Supported in a future ASA software release.

antonio-u by Level 1
  • 462 Views
  • 1 replies
  • 0 Helpful votes

Can ASA do NIC teaming? For example, can I take both eth0 and eth1,each NIC is 1Gbps each, and bond them into 2Gbps pipe?The reason I am asking is because I have a customer running Checkpoint Secureplatform NGx R65 and that the firewall can do NIC b...

Review Cisco Networking for a $25 gift card