Network Security

Hi, Recently I have started work on ASA and now I want to make backup Server and Syslog Server. Can anyone send a document. Is there anything else which i should make it for disaster recovery. Thanks

Hi,We have configured remote access VPN in our ASA5540. (ASA Ver. 7.2(2). We have 3 VPN groups setups. Sometime any users belongs to any of these groups diconnect after 05-06 seconds once they connected. Once I re-start the ASA all users are able sta...

I'm trying to get a tunnel up and running between an ASA 5510 and a Cisco 1812.On the ASA, whith debug turned on, i get the following: "... No crypto map bound to interface... dropping pkt"any hints?ct,

Hello'sI'm in the market looking to replace my current PIX firewalls. I've been looking at the ASA and the competition (Checkpoint, SonicWall) and was wondering if i could get some added expert opinion on how you think the ASA compares/competes.thank...

Hi,I'm not much up on Pix firewalls, so I am hoping someone here can answer this question: How would I modify the config below to allow ONLY The following IP's to access 10.2.2.8192.168.102.85192.168.111.60192.168.111.62192.168.111.50Running Config:(...

I am having a problem with accessing a web server that sits behind a PIX 515e running version 7.2(2)I have a static which translate the IP address on the external interface to a ip address on the internal network. I also have a access-list which allo...

Are ASA5505 able to work with 2 VPN site-to-site up in the same time and permit to navigate in internet?LAN behind ASA in a /24.ThanksNicola

Hi all,I need advice to creat a outside ACL for watchguard VPN trafic on our ASA.Below are a old ACL but no VPN watchguard trafic.Any sugestion?access-list acl_outside extended permit udp host -ip numbers removed- host -ip numbers removed- eq isakmp ...

Hello,Have an ASA 5505 7.2(3) behind a transparently-bridged aDSL modem, with ASA configured with PPPoE on outside interface. The PPPoE connection does not establish, with ISP stating it is an LCP issue.Quote from ISP: "I have seen this in other Ci...

Hello,I have seen that starting with sw version 8.0 it is possible to configure NAT with a firewall in transparent mode.I have an scenario where the upstream router (internet gateway) is performing NAT. Due to this reason sometimes the router proces...

I have a colo facility and a main office, both with 5510's. I have a leased line between the two 5510's. I have enabled the interfaces and can ping between the leased line interfaces - but I cannot ping between other local interfaces (Eth 0/3 and Eth...

Dear AllWe are having following scenario at one of the customers ISP Link -> L2 Switch -> IPS in Inline (VLAN)Mode -> PIX Firewall There are lot of Site to Site VPN tunnels terminated on the PIX Firewall; hence please let me know if the VPN traffic t...

Hi all,In our head office we have a pix506e and we have numerous remote offices with 877s. Each remote office has a site-site VPN connection to the PIX.The problem I'm having we recently added 8 new sites, only half of which work. They will all form...