Network Security

I have a remote site customer with a Cisco ASA 5540 running SSLVPN (Anyconnect)(8.03). It currently only serves about 450 SSLVPN clients. Since last friday, they've seen the CPU utilization go up to high 90% while only serving 400+ remote users. Plea...

Is possible to do function SDDE with IDSM-2 in Catalyst 6513 .The commands we need in Routers , bi example , are the next :ip http secure-serverip ips notify sde ip sdee .......But , in Cat6500 , woth SUP720 , MSFC3 , just permit version 12.2.sx... ....

Hello,I have setup an EZVPN connection between Cisco 851 (client) and PIX 515E 6.3(5) which is configured as an EZVPN server. Everything works OK, but the client is not allowed to save the password which is very annoying and makes the whole thing unu...

I have a firewall ASA-5510 ver 7.0 with 3 interfaces, one is connected to my internal LAN, one interface is connected to ISPs with public IP 203.27.53.112 and last is going to a router which is connected to another ISP with public IP 57.12.26.53. I a...

I can not seem to get this right. Im trying to load a new PIX configuration file to the startup config of a PIX515E so when a reboot is done, it loads the new config. This is for a ISP change at a live site. I guess TFTP would work and i could verify...

I have 4 active interfaces on my PIX 520, Outside, Inside, DMZ1BU, and DMZ2BU. Inside, DMZ1BU and DMZ2BU can nat to outside just fine, everything on the DMZ has a static mapping to and Outside IP Address. I'm trying to route between the two DMZs and ...

I need to monitor Site to Site VPN tunnels status for the coming period. I need to know which tunnels will go up and which ones will remain down. Can you help with the MIB that can moniotr this requirment or is there any other way to check the status...

I have an ASA 5510 that I want to tell the ASA to boot from a config file I have uploaded in flash using the boot config disk0:/imagename but when the ASA reboots it still loads the default config, why is this? I do a show bootvar and it show the con...

we are trying to create a web - filter on SDM using url List and block certain webistes. Could somebody help me how to go about this, i tried using the firewall settings by creating a firewall rule, but it doesn't reflect when the internet is accesse...

Is there a way to make the "show log" output from the pix firewall not to display the nameif names in its log.The present buffer logs are only showing the nameif names for the logs. what we need is to show the real interface name in log instead of na...

Hope this is the right spot...I've done searches and foud posts that are close, but no solution that has worked for me....Summary: My firewall is a PIX 506E. The other company is using Cisco routers on both ends to maintain the VPN. I have no access ...

hi everyone,i have an intersting query. We have a Cisco ASA 5540, running 8.0 setup in the normal fashion, 1 inside interface, 1 outside interface, 1 DMZ interface. we have a server in the DMZ that is statically natted to the outside interface. Here ...

I'd like to publish some specific portal views that limit users to specific views by role, across the entire system. I haven't found the docs for this or if this sort of functionality is even possible. I'd appreciate a point in the right direction.