Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

The boot sequence stop at this point:CISCO SYSTEMS PIX FIREWALL Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73 Compiled by morlee 128 MB RAM PCI Device Table. Bus Dev Func VendID DevID Class Irq 00 00 00 8086 7192 Host Bridge 00 07 00 8086 7110 I...

jasitalymil by • Community Member
  • 963 Views
  • 2 replies
  • 0 Helpful votes

Hi all, I manage pair of 515E (both 128MB) in failover mode. Few day ago I occured some akward situation: in 2-3 hours memory usage rise form standard 63MB to 112MB (w/o traffic rise) and than PIX no1 refuse all outside connection (all inside network...

klos_cioa by • Community Member
  • 705 Views
  • 2 replies
  • 0 Helpful votes

I want to put my FWSM in transparent mode. I have created the configuration on my 6500:firewall multiple-vlan-interfacesfirewall module 6 vlan-group 1firewall vlan-group 1 100,101!interface vlan 100ip address 192.168.100.1 255.255.255.0!Config in my ...

myoucef by • Level 1
  • 648 Views
  • 1 replies
  • 0 Helpful votes

I was reviewing the configuration a new ASA5505 running 8.0 and I saw the following statement in the configuaration: dynamic-access-policy-record DfltAccessPolicyNot knowing what the command does, I tried to remove it but an error stating I am not pe...

jon.axe by • Level 1
  • 2647 Views
  • 1 replies
  • 0 Helpful votes

Hi,Customer wants to implement NAC out-of-band in their organization. But he has some query:1. In out-of-band whether CAS will fetch the updates (AV, Patch management etc)from the corresponding servers & push the same to the end user?2. What will be ...

Hello, I'm currently looking into IDS placement and such. I had a thought about for a bit and wondered, what is the true difference between a Monitor Session off of a 3560 switch vs a true network TAP? Is there any way to get Layer 1 and 2 errors sen...

d1701 by • Community Member
  • 2074 Views
  • 5 replies
  • 0 Helpful votes

Hi all experts,i'm using PIX6.3(5) is it possible to route IPSEC traffic coming through one tunnel , decrypt , encrypt again and send it back through a new VPN tunnel.Basically an U-turn of IPSEC traffic on outside interface-> decrypt ->encrypt again...

Review Cisco Networking for a $25 gift card