Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I am trying to connect MS l2tp clients to asa 5505 and am unsuccessful. I have tried the ASDM VPN Wizard as well as CLI and missing something. I have attached my current config. My client hits the interface and logs an error 713048 Error processing p...

ricksrada by Level 1
  • 858 Views
  • 1 replies
  • 0 Helpful votes

Hello,I would like to implement QoS on Pix 7.0(4). We connect to our customers using Cisco VPN client(remote access VPN).I would like to prioritize this traffic, because these VPN connections are slow and e.g. browsing is fast.What is the best match ...

valsidalv by Level 1
  • 398 Views
  • 1 replies
  • 0 Helpful votes

I have a asa cluster in active/standby mode with lan cable connected for stateful failover. I want to know about the condtions when the box fails over to the other. One parameter should be the hello timers going between the failover interfaces. Doe...

Shobith K by Level 1
  • 704 Views
  • 1 replies
  • 0 Helpful votes

Goodmorning,I have a message on my pix 525 someone is spoofing on a server from my dmz. How can i prevent spoofing attacks? It goes something like that : Deny IP due to Land Attack from 10.10.8.1 to 10.10.8.1

I have a small project to authenticate around 100 users to access the network. We are planning to use the Cisco NAC appliance. Just to clarify (I have seen some post but I am not sure of the right answer) Do I need 2 separate appliances, one as serve...

hi guysi have entered a wrong mac address for my cas lic.acctully instead of my cam mac address i put my cas mac address in license webpages.now it give me the missmatch mac error .can u help me?thank you.

emadehsan by Level 1
  • 375 Views
  • 1 replies
  • 0 Helpful votes

Hi guys,I've got a strange problem here - I activated IOS IPS on both internal and external interfaces in incoming direction and also had to run CBAC on the incoming direction of the external interface. The result of all these things is that the IPS ...

I am able to connect to my PIX 515e but after I am connected I can't ping across it. I try to ping the inside from a PC that I have directly connected to the outside. Here is the config file, hope this helps.MTBFirewall(config)# sh run: Saved:PIX V...

reeddavid by Level 1
  • 935 Views
  • 4 replies
  • 0 Helpful votes

Hi,We have got a PIX 515E with the IOS version of 6.3(5)and got three interface which it was in use (for inside, outside and MPLS vpn)My requirement is to establish a new Leased line from the PIX to my customer point so i need to know there is any ch...

Review Cisco Networking for a $25 gift card