Network Security

What is the best way to create an exception rule for NetBIOS on the CSAMC? NetBIOS needs to be enabled because of resolving IP's within rules on the CSAMC.The process 'System' (as user NT AUTHORITY\SYSTEM) attempted to initiate a connection as a clie...

Is it possible to collect xlate information from a Cisco load balancer (CSS) for the purposes of sessionization and correlation in MARS?

Sir,i have two DSL Modems & Two Different Networks. i want that both Network traffic should be filtered through One Firewall means two in & two out ethernet Ports. Please help me that which firewall series i should use for it. Please reply me Soon.

Is it possible to remotely monitor this setup using SNMP via Orion? If the module fails, does it have an alert system built in, or can it be monitored remotely.

Is it possible to have 2 Internet connections to 1 Pix 515e running 7.2(2) code? I'm considering a design where there is a single firewall (only one available) but 2 paths to the internet instead of using 2 Pixs for redundancy. Is this even possible?

Hi folks. Can someone explain why I might be getting the following syslog from my ASA 5510:<166>%ASA-6-110001: No route to 127.0.0.1 from <IP address of ASA 'outside' interface>We do not have failover configured, however the 'internal control 0/0 int...

I need to remove a couple of outdated ACL's in my ASA, but when I use the command "no access-list outdated1", it says it's an incomplete command. I can't just go through and remove each line, as there are about 500 entries for each outdated acl I nee...

I have a scenario where there are users on two sites with thier own internet connectivity. Recently one of the ISPs had a significant outage, and therefore the users lost access.Is there anyway to detect such an outage, and re-route traffic through a...

Hi,My network is as below. Router | |Firewall--SERVER DMZ | | LANI have a peculiar problem wherin users accessing certain internet pages are getting page cannot be displayed error.For example after accessing hp.com, when i go for downloading of the d...

hi all,some vender told me that cisco ips can not work as both IPS/IDS, for examle, either my ports are inline, or passive not both so plz help if you can and a line to url to find that factthanks alot

Hello, I have erased the startup config and reloaded ASA 5510. Now its not able to boot preoperly.I used rommon mode to transferth image file to my ASA, the transfer is made succefully, but when i attempt to use copy tftp flash, i receive this error ...

Hi ,Can some one suggest me if it is possible to do a port based redirection to multiple internal servers on port 80 through single Public IP and on different ports.As per my attached configuration which i tried out i was able to get only one port ge...

Is ASA SSL Licensing additive?In other words, can I get to 150 licenses with a 50 and 100 user license? Or can I only have on license enabled at a time?I've been looking all over the place for this and can't find it anywhere. Thanks!