Network Security

Hi folks. Can someone explain why I might be getting the following syslog from my ASA 5510:<166>%ASA-6-110001: No route to 127.0.0.1 from <IP address of ASA 'outside' interface>We do not have failover configured, however the 'internal control 0/0 int...

I need to remove a couple of outdated ACL's in my ASA, but when I use the command "no access-list outdated1", it says it's an incomplete command. I can't just go through and remove each line, as there are about 500 entries for each outdated acl I nee...

I have a scenario where there are users on two sites with thier own internet connectivity. Recently one of the ISPs had a significant outage, and therefore the users lost access.Is there anyway to detect such an outage, and re-route traffic through a...

Hi,My network is as below. Router | |Firewall--SERVER DMZ | | LANI have a peculiar problem wherin users accessing certain internet pages are getting page cannot be displayed error.For example after accessing hp.com, when i go for downloading of the d...

hi all,some vender told me that cisco ips can not work as both IPS/IDS, for examle, either my ports are inline, or passive not both so plz help if you can and a line to url to find that factthanks alot

Hello, I have erased the startup config and reloaded ASA 5510. Now its not able to boot preoperly.I used rommon mode to transferth image file to my ASA, the transfer is made succefully, but when i attempt to use copy tftp flash, i receive this error ...

Hi ,Can some one suggest me if it is possible to do a port based redirection to multiple internal servers on port 80 through single Public IP and on different ports.As per my attached configuration which i tried out i was able to get only one port ge...

Is ASA SSL Licensing additive?In other words, can I get to 150 licenses with a 50 and 100 user license? Or can I only have on license enabled at a time?I've been looking all over the place for this and can't find it anywhere. Thanks!

I need to configure a ips module that resides in a 6500 with a MSFC card in it. Anyone know of a configuration guide for this? I cant seem to find one. Thanks.

When I try to lauch PDM on my PIX 501 by typing the ip address of the PIX in IE, I receive the following error:The startup wizard is not supported on the FWSM.These are the versions:Cisco PIX Firewall Version 6.3(5)Cisco PIX Device Manager Version 3....

I ran across an existing config that has two trunk ports on a 3560 being port monitored to another port which is plugged in to a port on an ids 4515. Will the IDS be able to interpret that trunk traffic? The customer is complaining that they aren't a...

Hello - I installed my IDS 4215 and I can get to the web interface on the management side. I set up a span on my IOS switch and CatOS switch (tried both) with the source as port n/n and the destination as the sensor port. I then set up IP logging for...

I have an ASA connected to the Internet running PAT. A CME (3745) is sitting behind the ASA. I wish to create a GRE tunnel between the 3745 and a 2600 on the Internet.Is it possible to pass GRE traffic through an ASA/PAT?Thanks!Tom

Hi, Installing two PIX-515E Firewalls (Failover Pair) on a customer site. The outside interface connects directly with a 10MBps link to the internet. When I am measuring throughput however, I am only getting an average of 2.5MBps download speed. When...