Network Security

The scenario I have is an ASA in context mode and I am looking to terminate VPN clients on a seperate ASA that has an interface on the same private subnet. I have added a route to the ASA context for the VPN pool that belongs to the VPN-ASA. i can pi...

i am having fwsm and want to configure a context for a customer in which i want to block 8081 port. can anyone let me know how to configure context in fwsm module (6509)regardsshivlu

Are there any commands for shaping traffic on the ASA? I have found the police command but none on shaping.

Hi Everybody,I have a problem. I made a VPN site-2-site with 2 ASA 5505. The VPN works great. And I create a redondant link if the VPN failed.In fact, I use Dual ISP with route tracking. If the VPN fails, the default route change to an ISDN router, s...

I've set up a number of site-to-site IPSEC tunnels, but the one thing that I can't seem to get is: Is there any way to bring the tunnel up if I am not actually at one of the endpoints?...usually I can just tell one of the people at either end to do a...

Hi, need helpIn my firewall i have no rule play in inside interface for outbound traffic but i have a rule play for inbound traffic in outside interface saying that from my particular branch network can access my server through SMTP.Just i wanted to ...

I have an older, decomissioned pair or 515e PIX firewalls configured in failover mode (active/passive). I now have a need to use them both in separate standalone modes, however when I try to use the PIX configured to act as the Failover secondary, it...

I am connecting a Cisco ASA 5505 and a Symantec Gateway 460R device via site to site VPN tunnel, and the Phase 1 (IKE) and Phase 2 (IPSec) negotiations go thru just fine. I show 1 active IKE and 1 active ipsec on the monitoring screen. However, when ...

Dear All,I facing an issue with routing in ASA 7.2, there is static route I want to remove it but, I could not When I'm doing sh routes it shows the route (S 10.*.*.* 255.255.255.0 [1/0] via 10.*.*.*, outside ) --> "this is the one I want to remove "...

Dear sir I would like your assistance regarding my network design between two sides.Details are as under. 1. My Side A using DSL (512 kbps)2. Side B Office is DSL (128 kbps) Secure tunnel is required between both sides and side B office should exactl...

I'm trying to establish remote access to my ASA; I can ping it, but telnet and ssh both are refused immediately. I know that Telnet isn't allowed into an outside interface, but ssh still doesn't work (I've already generated an rsa key, also).This dev...

8.0(2)6.0(2)Hello,We have a strange issue with our ASA5520 acting as an easy VPN server. We want to run IPSEC over port 10000 just like we did on our VPN3000 concentrators. This works fine for like 5 days and then all of a sudden the ASA stops respon...