Network Security

Hi,My customer have 2 FWSM modules installed at 2 PACS core switch, and runned as A/S mode, the firewall mode is route mode without NAT. The FWSM have 3 security zone : PACS, HIS & TJ. The core switches of PACS zone & HIS zone are at same computer ro...

I received some error msg.through the events in IDM. I would like to see if I can get some information on what these errors are and why they occurred. I have attached the error msg.Thanks

Hello, I recently took over the management of the CSA MC that supports all the server agents with ver4.0.3. It has been tuned by many various people. I see that all the agents were installed "WITHOUT NETWORK SHIM". Why? Does anyone know why the newor...

I can ping internal IP addresses all day long but I can't ping an external web address by name or IP, yet I can browse the internet just fine.

I upgraded our PIX 515E from 7.1 to 7.2.(2) about 6 weeks ago and noticed that it use more RAM, (about 43MB vs 34MB in previous version). After about 3 weeks I noticed i could not access through the ASDM, only telnet. Today the same issue, however th...

Hello,which hardware would you recommend me for following design. In the near future I will have to secure our mail server (1000 users), terminal servers 5 (100-200 users) and web server with firewall. I have 64 IP addresses and 100Mbit/s. Which devi...

We are getting the following error messages on our ASA 5510 with the following information:Inbound TCP connection denied from (yahoo mail server IP)/25 to (our outside IP)/15936 flags FIN PSH ACK on interface Outside We also have a queue of email to ...

I made a simple pix config for inside to access internet,,,For tht we have purchased 6 prublic ip's from isp provider, i m using one of the ip interface Ethernet0 ip address 202.63.101.68 255.255.255.248 interface Ethernet1 ip address 10.50.0.200 255...

Hi all,I am implementing IOS IPS on a 3800 router but I am not sure if when I enable it all the previous TCP sessions already active across the router will be dropped by the inpsect (because the IPS never saw when all those sessions started).Any comm...

Hi allI'm running a productive ACS 4.1 server that authenticates wireless users using LEAP. Today, we had a service outage, and when I look into the log, among other messages, I can see the following authen-failure-code: Internal error.It appeared se...

We are just about to purchase a Cisco ASA 5505 Security Plus Firewall and would like to know the restrictions of useing the 2 POE ports, can they be used as ordinary ports with out this feature ?Can you turn off the POE feature for these ports?Do the...

Can you add more than one community string to PIX firewall running 6.3?If so,Is it an ok practice to have a RW string on a PIX firewall in addition to the RO string?