Network Security

I'm trying to setup an SSL VPN box within a DMZ using a PIX 515. Basically I've setup the SSL box with a DMZ IP and NAT'd this to an external IP. I've put the following ACLs in:access-list INCOMING permit tcp any object-group SSL_BOX object-group WEB...

can someone advise me how i go about erasing flash on a pix 501 running 6.3(5)i am having boot up problems and would like to re-install the ios into a nice clean flash.regards Melvyn Brown

Hi! Greetings to allI have a Cisco ASA 5510. I need help with the basic configurations. I have a DSL Internet connections connected to the outside (Ethernet0/0) and my office network connected to the inside (Eth 0/1). I will require a DMZ interface l...

Hi,we have a remote site with 1 asa 5005 and 1 pix 501.the pix 501 has 2 existing vpn tunnels to networks 192.168.42.0/24 and to 192.168.48.0/24.the asa has another tunnel (easy vpn) to 192.168.1.0/24I added an inside route on the asa to .48 and .42 ...

I losed PIX 515E password and I want to do a action by the following recovery password procedure from Cisco official web site -http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_password_recovery09186a008009478b.shtmlI have a few question...

Hi, I'm using Cisco PIX515E and i need to erase flash completely and need to install OS 7.0 . PLease help me with commands to erase and to install OS 7.0 Thanks in advance

Dear All - I have an ASA 5510 running 7.0(5).I would like to upgrade to 7.2(2)22 - does anyone know if this is a recognized upgrade path?I have read here (http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a008067e9f9.shtml...

Hi, I have PIX 515E, when i switch on the this i'm receiving the following error.What could be the reason ? Please help me out to rectify this.Reading 1962496 bytes of image from flash.imgsum_config: sumval(0x28f8) md5(0x96a6bc99 0xfdcbe539 0x38a4f65...

Hi, access-list branch-policy line 43 permit tcp 172.16.0.0 255.240.0.0 host 172.30.2.140 eq 445 This is my ACL.But i wanted to know which are all systems are connecting to 172.30.2.140.the broblem is if the source systems are connecting always to 17...

I wonder that can we configure Time based Static nat i.e During Office hours my private IP to be natted to a Public IP but after office hours the IP should be natted to a diffrent public IP ? is it possible any ways ?

Hi, We have a 4MB internet line but for some reason it only show 300K if I have PCs running behind the pix. If I directly connect my PC to the ISP router then it connect at 4MB. Thanks in advance.

Hello everyone, I have a few questions that I could use some help on :).. I currently have a T1 link that has no QoS settings at all (L3). Through this link, we pass exchange traffic to offsite clients, all domain services, www traffic, and many othe...