Network Security

How many total interfaces can be created on the FWSM?

Hi,Can you provide me any docs regarding the advantages and disadvantages over PIX and ASA and vice versa.Basically I have a option to install only one device and performe all things( VPN, threat mitigation etc).Pls help.Bikash

Hi there,Is the IDSM capable of blocking host and network by itself through manual blocking. Or is it just capable of sending the blocks to its managed devices. Thanks

Hi,I cannot seem to find a way to Re-direct HTTP Traffic (For Non-Healthy) hosts when using 802.1X NAC (Its works fine with L2 IP NAC and L3 NAC).Using 3560 Switch I can put the Non-Healthy Hosts into a Quarantine VLAN but Is there a way to Redirect ...

I have a question as to whether the following scenario is possible to configured.I have a main site, that needs to create a VPN tunnel to remote client sites, assumably via a LAN-2-LAN connection. I need to be able to access all routable subnets on e...

when I run show config for my IPS. I noticed that their is a Virus update. Can someone tell me what this is. I have not been able to find an explaination of this anywhere. Thanks

I am running ASA5520 with Outside, Inside, Client and Branch interfaces. The inside interface connects to the Server farm network (192.168.0.0) only. The client interface connects all the clients on the LAN network (172.16.0.0) to the branches (throu...

i'm using IDS 4235 running IPS 5.1(5) with 4 Fast Ethernet card.when running in inline mode with default signature configuration it slows down all internet activities (I connected to the internet via 2M SHDSL).i don't know what is wrong ....??

How do you restore the PIX 501, 6.2 to its default values. "Erase" is not a command, "reload" will not work. Thanks.Said

TIA

My ISP give me a real IP, but restrict whit TTL=1 and i want NAT to my network 10.10.10.0/28. My router is 1811.and Ihave vlan1 on 10.10.10.0FOR NAT I use this:Router(config)#interface FastEthernet0Router(config-if)#ip nat outsideRouter(config)#inter...

Hi,I am collecting syslog from my ASA to my ciscoworks . I want to know how to set the level of the logging instances likelogging traplogging consoleDo I have to set to informational to get all traces of my firewall? It generates 1 gig off syslog/day...

We are trying to use VACL to capture routed interface traffic to the IDSM2 to monitor. The below is the sample configuration intrusion-detection module 3 data-port 2 capture!vlan access-map <name> 10 match ip address <ACL name> action forward capture...

I need to set up my PIX to route from my DMZ (10.10.50.0/24) to a network (192.168.10.0/24) that is connected to a switch on the inside network (10.10.100.0/24) via a router. The switch (10.10.100.2)on the inside network has a static route to the 192...

Ok I have a 515E pix firewall and I am trying to setup a Counter Strike Server. I enabled the necessary ports through the ACL. However when I try getting to the server on the inside/outside interface my server does not show up in the LAN or Favorites...