Network Security

I have a question as to whether the following scenario is possible to configured.I have a main site, that needs to create a VPN tunnel to remote client sites, assumably via a LAN-2-LAN connection. I need to be able to access all routable subnets on ...

when I run show config for my IPS. I noticed that their is a Virus update. Can someone tell me what this is. I have not been able to find an explaination of this anywhere. Thanks

I am running ASA5520 with Outside, Inside, Client and Branch interfaces. The inside interface connects to the Server farm network (192.168.0.0) only. The client interface connects all the clients on the LAN network (172.16.0.0) to the branches (throu...

i'm using IDS 4235 running IPS 5.1(5) with 4 Fast Ethernet card.when running in inline mode with default signature configuration it slows down all internet activities (I connected to the internet via 2M SHDSL).i don't know what is wrong ....??

How do you restore the PIX 501, 6.2 to its default values. "Erase" is not a command, "reload" will not work. Thanks.Said

TIA

My ISP give me a real IP, but restrict whit TTL=1 and i want NAT to my network 10.10.10.0/28. My router is 1811.and Ihave vlan1 on 10.10.10.0FOR NAT I use this:Router(config)#interface FastEthernet0Router(config-if)#ip nat outsideRouter(config)#inte...

Hi,I am collecting syslog from my ASA to my ciscoworks . I want to know how to set the level of the logging instances likelogging traplogging consoleDo I have to set to informational to get all traces of my firewall? It generates 1 gig off syslog/day...

We are trying to use VACL to capture routed interface traffic to the IDSM2 to monitor. The below is the sample configuration intrusion-detection module 3 data-port 2 capture!vlan access-map <name> 10 match ip address <ACL name> action forward capture...

I need to set up my PIX to route from my DMZ (10.10.50.0/24) to a network (192.168.10.0/24) that is connected to a switch on the inside network (10.10.100.0/24) via a router. The switch (10.10.100.2)on the inside network has a static route to the 192...

Ok I have a 515E pix firewall and I am trying to setup a Counter Strike Server. I enabled the necessary ports through the ACL. However when I try getting to the server on the inside/outside interface my server does not show up in the LAN or Favorites...

I am newbie asking for a primer on how to implement a 1721 installed with the latest K9 IOS as a Firewall.Specifically, are there any good white papers or other literature that can instruct me on the details of using 1721 in place if a PIX?This for a...

I have two vlan (subnet) on a 3550, can I configure a MAC access list to only allow MAC address A in vlanA to access IPB or MAC address B in vlanB ??Thanks

Hi All,I have trouble logging into PDM from the inside interface. I can connecgtg ok but I think the process fails at authorization stage. The follwoing message is posted in the browser status window:exception: java.Security.AccessControlException: A...

I have two diff. Pix 5510's that show diff crypto isakmp statements for creating crytpo tunnels. The statements are slightly different for the current version of IOS used. Wondering if the diff vers of IOS causes the obvious difference in statements?...